It keeps dispaling FL in the panel - Maytag Neptune MAH5500B Front Load Washer

Search Results

Why am I getting an FL error code on a Kenmore Calypso ...

www.shopyourway.com > Manage My Life > Questions
I have a Kenmore Calypso washer model 11022062100 and there is water in ... Why am I getting an FL error code on a Kenmore Calypso washing Machine?

check the connection to the motherboard, see or look at the power connection, if the power connection is connect try flipping the power connection around, if you tried that try and look for the positive side plugging in the hot wire to the + side hot wire ti control panel, if you are still having issues go on line see if you can find the layout of the connecting pins on the motherboard there a lot of different configurations for the led lay out and you connect it the wrong way you will short out the led display.
you try manufacture first
than try: www.allpinouts.org/motherboard manufacture name
http://www.pinout.ru/

www.similarweb.com/websites/allpinouts.org

thank you rod

IT MEANS IT WAS UNABLE TO READ THE CD! TRY CLEANING IT WITH AN LCD CLEANER, AND TRY IT AGAIN! IF IT SHOWS AN ERR, YOU MAY NEED TO REPLACE THE CD UNIT!

thermiter open ditection

is everything else working fine? if so you may have bad solder connections on some surface mount resistors inside the radio.

sounds like bad pump

The FL error code means:
Flood Condition:
FL flashes if any overfill condition occurs. This condition occurs when excessive water in the tub causes the overfill switch to trip. The control must realize that the trip was due to an overfill condition instead of a suds lack condition in order for FL to be displayed

With an overfill condition, the beeper repeats a warning every 10 seconds with no time-out. The pump is cycled in drain mode for 30 seconds on, 30 seconds off until the overfill switch resets or power is discontinued to the unit.

Press STOP/CANCEL to clear the display.

This problem I see on these are the water pumps getting clogged with lint or other things, causing the pump not to pump all of the water out at times.

There is a check "valve" in the drain assembly that seems to sometimes cause problems with the FL error code. You can remove this piece, and might avoid changing the pump.

Calypso Service manual: https://docs.google.com/leaf?id=0B5If-wTgYWH5MTQ0OGIxZTAtZjQyMy00MzEzLWJkMzYtZTdmOTY2OTk3YTA4&hl=en

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

go to control pNEL IN SETTINGS THEN U FIND DISPAL;Y open dispaly AND u r on theme tab change theme to otheru like.