I also needed a new screen to screen power cord. Call 1-866-553-7521 and give them the model # PDE 2717. Ask specifically for the screen to screen power cord because the first cord the see when they do a look-up is the car to screen cord. The cost was $6.00 but adding in shipping brought the total to $15.99. Expect the delivery in 7 to 10 business days. Thanks and enjoy!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It is now confirmed that your emerson is faulty. Please remove the connection open the set if there is no breach of warrranty- if new- and look inside. try and tighten all the connector points, the joints, the flat cords. check the leadds to the front panel and check for any breaks. Assuming this was working earlier and has failed now, then you will need to check on the display/ processor for failure. If aftera ll this check the light are staying on then you have a possible failure of the micro processor. confirm with a signal check, frequency oscillation and if not present replace. Helpful? Good day
Well stupid of me, i must have checked all wiring first...Audio cable was faulty and my infrared audio unit popped. Must search for agency in South Africa to buy new infrared unit? Can the headrest screens be bought through agents as well? I'ts for e46 bmw.
the best solution is to call the company and see if they can send a new one or you try to take the cover off and find the safety switch and krazy glue it down so it will operate be advised that any jaring or moving may make the disk skip. thank you for your question
My PDE 2625n worked on the way to Mimi's and starting on the way home it displayed "Disk Loading..." then errord out with "Bad Disk". I dug through the internet and over 3 days found the answer.
Your laser is tired. Since the DVD player is cheap, replacing it is not worth the $$. Fix it! Remove the back cover (about 10 small phillips screws). It is important to know that their is a back plate AND a back panel; remove the PLATE which should have a model number sticker.
Now you should see a circut board with a set of polished rails which holds the read head. On the read head (by a ribbon cable ) are two very, very, very small flat blade POT screws. These control the amount of power sent to the laser. Turn the right most one CLOCKWISE about a 1/8 to 1/4 turn.
You can test your handy work by popping in a DVD while the cover is off and seeing if it loads. If all is ok, put it back together. If not turn it a little more. I used a car battery charger to run my test since it's about 25 degrees outside.
Be aware the more power sent to the laser, the faster it burns out (according to my research). By feeling is the DVD player is broke, so what? Am I going to break it? What the hell;) and I cranked away.
BTW I just got this fixed this morning. My kids are screaming with joy for DVD's in the car again! I'm thrilled that I don't have to spend $100 or more to replace this unit.