- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You may need raid controller driver for HP proliant ml 350. Copy raid controller driver in flopy disc, insert it in flopy drive, insert cd in cd driver, boot server from cd and start installation process, as soon as you see Press F6 if you need to install third party scsi drivers or raid controller, press F6 and follow the instruction. It will then ask you to select RAID driver file and then will continue to windows xp installation.
The system is not designed to use IDE hard drives which why you are getting a blue screen. It is designed to use SCSI hard drives and IDE CD/DVD drives. It might be possible to go into the server's BIOS setup and change the boot device from the onboard SCSI controller to the IDE controller. It is very likely that you will have to disconnect all SCSI devices to boot to IDE, if it is possible. I hope this helps.
The hard drive needs to be set as the first SCSI ID device boot device..
The hard drive needs to have the jumper set to SCSI ID 0, the CD and FDD can be set to SCSI ID 1 and SCSI ID 2. No SCSI devices can have the same SCSI ID number unless it is on a different SCS controller.
The SCSI driver is required to installed during the initial boot up for installation when additional drivers are asked .the new models dont come with a Floppy drive so an external floppy drive can be used .The detection of HDD s must be at the startup by the Bios os SCSI card.
The SystemEventLog may become full of erroneous IPMI Events reported by the System
BIOS. When this occurs, the following message may appear during
Power-On Self-Test (POST) and POST cannot continue without user input: 02a2: BMCSystem Error Log (SEL) Full
Press F1 to Continue, Press F2 to Setup If the above message appears during POST, perform the following steps to run BIOS setup and delete the SystemEventLog:
Boot the server and press the F10 key when prompted to run BIOS Setup.
Select the "Advanced" menu.
Scroll down to "IPMI" and press the ENTER key
Scroll down to the SystemEventLog and press the ENTER key.
At the "Clear SystemEventLog" selection, press the ENTER key to toggle between "Enable" and "Disable."
Press the F10 key to Save the changes and exit the BIOS Setup.
To get to the BIOS for your server, press F10 at start-up. This should get you there to verify if settings are detecting SCSI devices. If they are there, you may have to reinstall the SCSI controller drivers. Good Luck.
Hi there you have the insight diagnostic cd boot the server with it then when you boot be careful not to erase the server there you will find the offline diagnostics tool where you can select the HDD you want to diagnosis if the hdd fails it will alert in red color its that sinmple
If you are booting the server from a Windows installation disk and it is unable to detect the hard drive, this typically means the following things. You need to provide the driver for the RAID controller of the server (this can vary, depending on the version of the ML370 e.g. G4/G5) If it still cannot detect the hard drive after providing the driver for the RAID controller or if there is not a driver available for NT4, it may not support the controller. In this case you can remove the RAID set by entering the RAID setup (could be LSI or adaptec). NOTE THIS WILL DESTROY ALL DATA ON THE DISKS THAT ARE A PART OF THIS RAID SET.