MGR5755QD CleanDesign Gas Kitchen Range: We purchased a new Maytag range. The LP kit numbe...

Yes, there is an LP conversion kit for the CPR1100ADW. Sears Parts Direct lists it here: http://www.searspartsdirect.com/model-number/cpr1100adw/1429/0124002.html . Select the Gas Control drawing. The direct link to the LP orifice kit, part number 74009923, is http://www.searspartsdirect.com/part-number/74009923/0022/464.html?modelNumber=CPR1100ADW&categoryName=Free%20Standing,%20Gas&brandName=MAGIC%20CHEF . Note: the Magic Chef range uses the same parts as a Whirlpool or Maytag range.

The gas regulator also has to be adjusted. Most ranges with converter kits available just require the regulator to be removed and turned 180 degrees before replacing it. It's recommended that a LP service person do the work. The air flow may need to be adjusted and any mistakes could be dangerous.

I hope this helps.

Cindy Wells

Hi,

The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating

Oven Problems Replacing the Igniter


heatman101



dfasfdas

Hi.

It can be fixed.

The part that is most commonly causing the problem is the temperature sensor.

When the problem is the temperature probe, both baking and broiling functions are affected.

Regards.

u would need an lp kit some of the ranges came with the unit check the unit pull the drawer out and check below maybe taped to frame or chcek the rear backside for some orfices, u are gonna have to replace the orfices on the top burners.. also if its gas oven the same will be required by flipping the cap to the regulator and making some adjustments inside as well..... hope this help

Hello. Contact your propane provider and they will get you the conversion kit for your maytag model. In fact, they will send a technician to your home for free to make the conversion for you.
If you want to do it yourself go to any appliance store that handles maytag and get the conversion kit. Then remove the orifices that are currently in the stove and replace them. Regards, Joe
PS please rate my answer.

Your range should have came with a conversion kit. If not I would call Kitchenaid.

Contact the appliance manufacter and ask for a conversion kit. This should be done by qualified persons only.

glow plug needs to draw 4 amps to open gas valve even if it red hot ...not drawing 4 amps replace glow plug
thumbs up

Yes you can convert the range

2. Provide an adequate gas supply.
This unit is pre-set to operate on 4" natural gas manifold
pressure. Aconvertible pressure regulator is connected to the
manifold and MUST be connected inseries with the gas supply
line. If the LP/Propane conversion kit has been used, follow
instructions provided with the kit for converting the pressure
regulator to LP/Propane use. The LP kit can be found on the
back side of the range (some models).

I yours does not have the kit on back go to sears to get one.

Good Luck

Please rate FixYa!

Is this a model# FGF337EC ?

LP Conversion Kit,w/instructions GRLP2

around $25