Unit does not fully power on. Power led flashes wireless led does not flash. Will not respond to hard reset from the adaptor. Is this unit unrecoverable? what can be done?
SOURCE: unable to reset my tsunami mp.11 5012-sur
Use reset button! If you have pushed Reload button, you have too flash new firmware from TFTP server.
SOURCE: what is default password of mp.11 5054-r
default password public default address 10.0.0.1 no Username
manual below
http://www.rudolfov.cz/internet/proxim/5012-SUR_QIG_v3.0.1_CD.pdf
This is battery
related. On top of your unit is a battery pack with three colored led
lights. You can tell what is going on by looking at these. This
information is in your manual or here it is.
GREEN LED: All systems are normal. A solid LED light indicates
the batteries are fully charged. A flashing LED indicates the
batteries are being charged. NOTE: Batteries do not have to be fully
charged to operate the motor unit. YELLOW LED: The motor unit has
lost power and is operating off of the BBU. A solid LED with beep,
sounding approximately every 2 seconds, indicates the motor unit is
activating the door and is operating off of the BBU. A flashing LED
with beep, sounding every 30 seconds, indicates batteries are low.
Once the power is restored the BBU will recharge. This is indicated
by a flashing GREEN LED. RED LED: An error has been detected and the
BBU will automatically shut off. The BBU will attempt to restart by
reconnecting to the batteries. If the error is still present it will
shut itself off again. This process will repeat every 5 minutes or
until the error has been resolved. This is used to prevent further
draining of the batteries. If a red LED remains on when the power is
restored, and is accompanied by a beep sounding every 30 seconds,
please call for service.
This is battery
related. On top of your unit is a battery pack with three colored led
lights. You can tell what is going on by looking at these. This
information is in your manual or here it is.
GREEN LED: All systems are normal. A solid LED light indicates
the batteries are fully charged. A flashing LED indicates the
batteries are being charged. NOTE: Batteries do not have to be fully
charged to operate the motor unit. YELLOW LED: The motor unit has
lost power and is operating off of the BBU. A solid LED with beep,
sounding approximately every 2 seconds, indicates the motor unit is
activating the door and is operating off of the BBU. A flashing LED
with beep, sounding every 30 seconds, indicates batteries are low.
Once the power is restored the BBU will recharge. This is indicated
by a flashing green LED. RED LED: An error has been detected and the
BBU will automatically shut off. The BBU will attempt to restart by
reconnecting to the batteries. If the error is still present it will
shut itself off again. This process will repeat every 5 minutes or
until the error has been resolved. This is used to prevent further
draining of the batteries. If a red LED remains on when the power is
restored, and is accompanied by a beep sounding every 30 seconds,
please call for service.
This is battery
related. On top of your unit is a battery pack with three colored led
lights. You can tell what is going on by looking at these. This
information is in your manual or here it is.
GREEN LED: All systems are normal. A solid LED light indicates
the batteries are fully charged. A flashing LED indicates the
batteries are being charged. NOTE: Batteries do not have to be fully
charged to operate the motor unit. YELLOW LED: The motor unit has
lost power and is operating off of the BBU. A solid LED with beep,
sounding approximately every 2 seconds, indicates the motor unit is
activating the door and is operating off of the BBU. A flashing LED
with beep, sounding every 30 seconds, indicates batteries are low.
Once the power is restored the BBU will recharge. This is indicated
by a flashing green LED. RED LED: An error has been detected and the
BBU will automatically shut off. The BBU will attempt to restart by
reconnecting to the batteries. If the error is still present it will
shut itself off again. This process will repeat every 5 minutes or
until the error has been resolved. This is used to prevent further
draining of the batteries. If a red LED remains on when the power is
restored, and is accompanied by a beep sounding every 30 seconds,
please call for service.
This is battery
related. On top of your unit is a battery pack with three colored led
lights. You can tell what is going on by looking at these. This
information is in your manual or here it is.
GREEN LED: All systems are normal. A solid LED light indicates
the batteries are fully charged. A flashing LED indicates the
batteries are being charged. NOTE: Batteries do not have to be fully
charged to operate the motor unit. YELLOW LED: The motor unit has
lost power and is operating off of the BBU. A solid LED with beep,
sounding approximately every 2 seconds, indicates the motor unit is
activating the door and is operating off of the BBU. A flashing LED
with beep, sounding every 30 seconds, indicates batteries are low.
Once the power is restored the BBU will recharge. This is indicated
by a flashing green LED. RED LED: An error has been detected and the
BBU will automatically shut off. The BBU will attempt to restart by
reconnecting to the batteries. If the error is still present it will
shut itself off again. This process will repeat every 5 minutes or
until the error has been resolved. This is used to prevent further
draining of the batteries. If a red LED remains on when the power is
restored, and is accompanied by a beep sounding every 30 seconds,
please call for service.
This is battery
related. On top of your unit is a battery pack with three colored led
lights. You can tell what is going on by looking at these. This
information is in your manual or here it is.
GREEN LED: All systems are normal. A solid LED light indicates
the batteries are fully charged. A flashing LED indicates the
batteries are being charged. NOTE: Batteries do not have to be fully
charged to operate the motor unit. YELLOW LED: The motor unit has
lost power and is operating off of the BBU. A solid LED with beep,
sounding approximately every 2 seconds, indicates the motor unit is
activating the door and is operating off of the BBU. A flashing LED
with beep, sounding every 30 seconds, indicates batteries are low.
Once the power is restored the BBU will recharge. This is indicated
by a flashing green LED. RED LED: An error has been detected and the
BBU will automatically shut off. The BBU will attempt to restart by
reconnecting to the batteries. If the error is still present it will
shut itself off again. This process will repeat every 5 minutes or
until the error has been resolved. This is used to prevent further
draining of the batteries. If a red LED remains on when the power is
restored, and is accompanied by a beep sounding every 30 seconds,
please call for service.
60 views
Usually answered in minutes!
×