Question about HP Pavilion F1903 19" Flat Panel LCD Monitor

1 Answer

Monitor Repair Can you recommend how I can find someone to repair the capacitors in my monitor to see if this is the same problem I am having? I called several repair shops and they don't repair monitors...

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 472 Answers

Goto your local Radio Shack or computer shop and ask if they know of any repairers in the local area. Chances are they have someone from such a place they supply equipment or parts to.
If you were in Australia I could do it in a flash.

Hope it helps =)

Posted on Apr 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Crt monitor gives only yellow colour


hi this is due to some internal fault like ur capacitor might have burnt or due to failure of picture tube i recommend u to show ur monitor to a monitor or T.V repair shop rather than repairing yourself because it's hazardous so take ur monitor to some repair shop and also check ur warranty and get it repaired. was this helpful to u if yes please do rate my solution.
with warm regards -bonefirediv

May 21, 2011 | Computer Monitors

1 Answer

Vertical line on my moniter. i have complaint to the customer service but didnot got any responce.please help


unfortunately, this is a defect that is very prevalent in LCD monitors. Sometimes applying pressure to certain areas of the screen will cause the symptom to disappear. Attempting to repair this is not recommended and should be done only be someone who is highly skilled at monitor / television repair. If the monitor is still under warranty I would recommend getting it replaced. Otherwise you may be better off just purchasing a new monitor as the cost to fix this problem may very well exceed the original cost of the monitor.

May 24, 2010 | ViewSonic VX910 19" LCD Monitor

2 Answers

Turned on the monitor this morning and it would not come on. Several tries, no luck. The 'on' light flashes green/red together. Bought 12/07. Can you help? (I've borrowed a friend's monitor to contact...


If you are to DIY repair, please read below so you will at least know what to look for.
Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://en.wikipedia.org/wiki/Capacitor_plague

http://www.badcaps.net

May 01, 2010 | Westinghouse L2046NV Monitor

1 Answer

Monitor is taking forever to load


Thats all normal... sounds like a signal interface problem, You may be able to fix it, but you will need a soldering iron, solder, a meter, the service manual & time, First step get a service manual, then check if your power supply voltages are correct and work out from there. It is NOT easy, I have been doing this all for over 30 years and never the same fault twice. professionally I recommend a new one, or why not take it in for repair, ask for a "Quote" for repair, and then you can make an informed decision as to repair or replace...

Mar 22, 2010 | Acer AL1912 19" LCD Monitor

1 Answer

Monitor only lights for a couple of seconds


These monitors have problems with bad capacitors, transistors and inverter boards. This is a common problem with all monitors. If you are comfortable taking the monitor apart, you should inspect the capacitors to see if any are swollen. If they are, you might try replacing them. If you are not comfortable with taking it apart I would recommend taking it to a reputable repair person. If it is capacitors or transistors, the repair could be cheaper than a new monitor. If it is the inverter board, depending on the cost of the inverter board, it mat be cheaper to just get a new monitor.

Jan 01, 2010 | Samsung SyncMaster 931B 19" LCD Monitor

2 Answers

When turned on, monitor power light comes on for a moment and then goes out. Monitor eventually comes on after several minutes. The same happens if the monitor is left on but goes into sleep mode.


This is a common problem on these monitors. There are three or four capacitors in the power supply, three on the inverter board and anywhere from 2 to 6 on the main board that go bad.

The number on the main board depends on how long the monitor has been having problems before it was serviced. The longer the wait, the more capacitors will have gone bad.

The power and inverter boards are easy to repair, the main board is not. As mentioned, it is a multi layer board so removing the old capacitors and the old solder can be troublesome. I would suggest you have someone experienced at soldering repair the main board.

Btw, our shop would charge $60 labour plus $2 for each capacitor.

Dec 18, 2009 | ViewSonic VP2030b 20.1" LCD Monitor

1 Answer

Dell flat screen monitor does not come on after


Sounds like a capacitor on the power strip inside the monitor is failing.
The cost to repair can run $400.00. A tv repair shop may be able to fix it, but most technicians recommend buying a new monitor.
However, if you are experienced in electronics, you can disassemble the monitor and replace the capacitor. Radio Shack sells them for between $15 to $20.

Oct 10, 2009 | Dell E173FP 17" LCD Monitor

1 Answer

I-inc CY199 monitor will not turn on


Hello,

It sounds like you have a monitor with a common problem, we have repaired many Hanns-G monitors with this problem. After a few years some LCD monitors will blow a power supply. The problem is caused by parts called capacitors overheating in the confined space of the monitor. If you are good at electronics repair/soldering you can usually fix the problem. Check out a few pictures on my web site www.ccl-la.com/badcaps.htm You can take the back cover off your monitor and look for the bad parts,replace any that look like the pictures and your monitor should work fine. The capacitors do need to be installed with the correct + and - connections, note the stripe on the old one and insert the new one the same way. If you can't do the repair we offer a repair service, contact us for more details.

I hope this helps, if so please rate my solution.

Buddy
Corporate Computer
www.ccl-la.com
Over 21 years of computer and printer support/repair

Aug 10, 2009 | Hanns.G Corporation JW-199DPB 19" LCD...

2 Answers

Monitor is going out...


hello
I am a technician-informatic. I have repaired about 80 Lcd Samsung monitors with theese problems. I offer the repair manual.
Manual has been done with the experience of the repairing Samsung Lcd monitors. Manual was made by me and shows how to open monitor, how
to solve dark screen problem, how to check and replace capacitors, how to solve the problem non-optimal mode (without reprogramming MCU or
changing the main board) photo are included. 100% functional. The repair process is very simple 30-40min. (does not need a lot of
experience in electronics and expensive instruments) and is not expensive. With this manual you can solve problems by yourself and save
money.

"Not Optimum Mode 1280x1024 60Hz"
- The monitor turns on but turns off by itself, the LED blinks green.
- If you detach from the PC points to "control cable" the picture runs continuously in the vertical direction or presents while line , and
as soon as it is reconnected, the monitor goes off.
- The monitor does not turns on and dont dispaly anything, the LED blinks green-lit, if you detach from pc points to "control cable".
- The monitor turns on, works well some time, but after a window apiers "Not optimum mode. Mode recommended 1280X1024 60Hz"
- The monitor turns on, works well only with low resolution 800x600, when try to change a window that reads "Not optimum mode. Mode
recommended 1280X1024 60Hz"

the manual you can find on ebay (my ebay name is asnerejas123):
Samsung monitor repair manual guide 710n,913v,510n more
220498646211
Riparazione - repair Lcd Samsung monitor 710n,913v,510n
220498645860
Reparaturhandbuch für Samsung 710n,913v,510n und andere
220499443698

Jul 01, 2009 | Samsung SyncMaster 940N Flat panel Monitor

Not finding what you are looking for?
HP Pavilion F1903 19" Flat Panel LCD Monitor Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Computer Monitors Experts

Tony Isted

Level 1 Expert

49 Answers

olayoju victor

Level 2 Expert

191 Answers

John Trigg

Level 2 Expert

250 Answers

Are you a HP Computer Monitor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...