Question about Frigidaire GLEQ2152ES Electric Dryer

2 Answers

Dryer will not run

The lights all come on and there is a snap sound when I push the start button but the dryer doess not start

Posted by on

  • lazyq Nov 26, 2008

    dryer has power, lights work. It was in use, stopped to add clothes and would not restart. switch makes a humming sound when pushed, but won't start.

  • angelique Jul 26, 2013

    I have the same problem

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Dryer starts sometimes if you hold in button. frigidaire gallery series model # GLEQ942CSO. serial # XD350164472. flat panel control board.

Posted on Jun 29, 2013

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Dryer starts sometimes if you hold in button. frigidaire gallery series model # GLEQ942CSO. serial # XD350164472. flat panel control board.

Posted on Apr 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clothes dryer does not work when power turned on at wall. Sounder goes continuously, no lights on panel and panel buttons do nothing


If it didn't do that before removing the capacitor & wires then I would assume it is something you have done wrong. Maybe put a wire back in wrong place. There is a wiring diagram on back of dryer. Motor not starting could be the capacitor, you really need to test it with a capacitor tester. It may also be the motor bearings seizing up. If motor is tight to turn when belt is off then it will be time for a new dryer. Too expensive to replace the motor on such an old dryer.

Jan 03, 2016 | Fisher and Paykel Dryers

1 Answer

Dryer light stays on when door is shut nd wont run


check the door switch,i don't work on lg but on any other dryer if the wsitch is broke the dryer won't start and if the light is on the switch shuts off the light and dryer will start.if you send the model number i can look up the switch for you.open the door and look around the frame where the door closes into,there should be a push button switch or a little paddle that the door hits,when you push in on the switch it should make a clicking sound or i've seen the paddle broke off.hope this helps or if you removed any wires to the door switch you might of wired it wrong

Mar 30, 2013 | LG Dryers

1 Answer

I have a whirlpool duet gas dryer model ggw9200lw1. when i press the start button it clicks once but wont run.


First, check the door switch. Push and release it by hand and you should hear a click. If no sound, replace the door switch with this part.
If the switch is ok, press the cancel button on the machine. Then do this. press and hold the start button for 2 seconds then release wait 2 seconds and press and hold again for 2 seconds continue this pattern until the dryer goes into test mode. You will see all the lights on the control light up. press each button on the control one at a time 3 times each. (Do not press the cancel button) until the dryer begins to run. When the dryer starts to run then press the cancel button. Then your machine should function properly.

Oct 19, 2012 | Whirlpool Duet 7.0 Cu. Ft. Super Capacity...

1 Answer

When I push the "push to start" button (knob) on


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Mar 14, 2011 | Kenmore Dryers

2 Answers

Push the start button. The dryer will run. Release start button and the dryer stops. The end of cycle chime sounds. The timer ticks. Placed all controles in every position and the results are the same.If...


probably has a broken belt,there is what is called a "Broken Belt" switch by the motor inside on the idler pulley tensioner for the belt,if the belt breaks this switch opens so the dryer wont run without the drum turning so as not to overheat and burn your clothes,replace the drum belt and you should be good to go

Jan 21, 2011 | Whirlpool GEW9878LW Electric Dryer

1 Answer

I have a Frigidaire LEQ2152ES Electric Dryer. The light comes on when you open the door. And the lights and sounds come on when you push the settings. Push the start button, and you hear the tick for...


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Sep 15, 2010 | Frigidaire GLEQ2152ES Electric Dryer

1 Answer

Dryer turns on but does not start when i push the start button. The timer comes on all the buttons light up, light is on inside dryer, but does not start just makes a sound when i hit the start button


if it's a humming sound the motor is bad or something is jammed keeping the motor from spinning.open the dryer door and move the drum by hand if the drum can't be moved the belt could be jammed on something or there's something stuck in the blower wheel.the blower wheel is behind the duct that the lint filter slides into.if you can move the drum then you most likely have a bad motor,try spinning the drum and push the door switch in and have someone else push the push to start button and see if the dryer will start,if the motor has a flat spot it could start like this.let me know what you find

Jul 14, 2010 | Kenmore 62602 Electric Dryer

1 Answer

Dryer doesnt run when i push the start button light inside comes on when i open the door but nothing happens when i go to start it


Hi,
There can be many reasons why your dryer2_bing.gif will not turn...

This tip that I wrote will help you to figure out what is happening...

Dryer2_bing.gif Repair - The Dryer2_bing.gif is not Turning
http://www.fixya.com/support/r4422207-dryer_repair_dryer_not_turning

Dryer2_bing.gif Repair ? The dryer2_bing.gif will not start
http://www.fixya.com/support/r4460438-dryer_repair_dryer_will_not_start


heatman101

May 20, 2010 | Dryers

2 Answers

Dryer stops when I release push to start button


Timer may need to be replaced. You can test it with an ohmmeter or test light.
You can do the same with the push button. If you have more problems, then the main control could be faulty

Sep 10, 2009 | Whirlpool GEW9878LW Electric Dryer

1 Answer

Brand new Dryer starts then stops after 15 seconds


Stop what you are doing. It is under warranty. This will be more costs and it is not necessary. It is a mfr problem.

Feb 08, 2009 | Frigidaire Affinity 5.8 Cu. Ft. Electric...

Not finding what you are looking for?
Frigidaire GLEQ2152ES Electric Dryer Logo

Related Topics:

720 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Are you a Frigidaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...