Question about Amana DLE330RAW Electric Dryer

1 Answer

Dryer taking a long time to dry

My dryer is taking a long time to dry clothes. I replaced the heating element, cleaned all the vents and screens. It takes about 2.5 hours per load. Is the problem the heating sensors. It seems like it is not getting hot enough???? Any suggestions

Posted by on

  • vavm Oct 09, 2008

    Even mine take a very long time. A medium load takes about two cycles of 1 hr run. ughhh! if someone can help me i will appreciate

  • mykarenina Oct 20, 2008

    My dryer is less than 1 year old and has worked perfectly until two months ago. It now takes 2 to 2.5 hours to dry one regular load of clothes. I replaced the heating element and the vent hose and vacuumed out the entire lint collection area even though it looked completely clean. As the dryer is under warranty I called the Amana repairman who came to the house and said there is nothing wrong with the dryer and it "should be working fine." It still isn't. Any solution would be appreciated.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 734 Answers

I am sending you all the possibilities for your problem, check either of these causes ----and than let me know if it is solved----

Power from the house
Check to see whether there's power getting to the dryer. Is it plugged in? Check for blown fuses or tripped circuit breakers--your dryer uses two fuses or circuit breakers. The dryer could tumble but not heat if only one of the two fuses is blown. If you have circuit breakers, one of the two circuit breakers can trip, even if the two for the dryer are connected.


Heating element
Often a dryer heating element burns out, but doesn't trip the circuit breaker or blow a fuse. The heating element is simply a long coil of special wire. You can check it for continuity with an ohm meter. No continuity means the element is bad and you need to replace it--electric heating elements aren't repairable.


Thermal fuse
On many dryers, there's a thermal fuse mounted to the exhaust duct inside the back cover panel. The fuse--which is about an inch long--is usually embedded in black resin and mounted in a white plastic housing. If the fuse has blown, you need to replace it. (You can't re-set it.)


Wiring
A common problem is for the main wiring connection from the house, at the dryer, to burn and break its connection. Because the dryer can still tumble with partial power, the connection may be only partially defective. You may need to replace both the power cord to the dryer and the terminal block inside the dryer that the wire is attached to.

Posted on Dec 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dryer takes 2 times to dry clothes


Check the following areas thoroughly to address this issue.


1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.

Aug 17, 2009 | Whirlpool Dryers

1 Answer

Not drying properly, no heat


Check the following areas thoroughly to address this issue.


1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.

Aug 06, 2009 | Dryers

2 Answers

My dryer takes long time to dry the clothes. It


Check the following areas thoroughly to address this issue.


1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.

NOTE***(This unit is equipped with a dryness control board. if all points above check out ok, replace this board).

Jul 21, 2009 | GE Profile Harmony DPGT750EC Electric...

2 Answers

Whirlpool dryer....heats


You could have heating element going bad, or a plugged dryer vent. Start with dryer vent, make sure all lint is out of it, all the way through it, even if it goes to the roof, or out the wall. Also vacuum out back of dryer and inside vent tube. This should help with problem. If not then replace heating element its getting weak.

Jul 19, 2009 | Whirlpool LER4634J Electric Dryer

1 Answer

My dryer takes 2 to 3 cycles to dry my clothes.


Check the following areas to combat this issue. in most cases, this will be a Venting issue.

1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.

Jun 21, 2009 | Whirlpool LER4634J Electric Dryer

1 Answer

The dryer is taking a long time to dry clothes and can only use the timed dry or touch up setting.


Check the following areas to address this issue.

1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.


Jun 17, 2009 | Kenmore Elite HE4 Electric Dryer

1 Answer

Dryer won't heat up to dry the clothes the heating element works


Check the following to address this issue--


Note: Normal drying time for a dryer is about 45 minutes (some may take up to an hour).

1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.

Jun 03, 2009 | Kenmore Dryers

1 Answer

Not heating properly, many cycles to dry loads


Check the following to address this issue--


Note: Normal drying time for a dryer is about 45 minutes (some may take up to an hour).

1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.

Jun 02, 2009 | Maytag SDG3606A Gas Dryer

1 Answer

Clothes won't dry


Check the following to address this issue.


Note: Normal drying time for a dryer is about 45 minutes (some may take up to an hour).

1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.

Jun 01, 2009 | Whirlpool ET8CHEXSQ Dryer

1 Answer

Does not completely dry clothes in the time it used to


For Electric Dryers, check the following---


1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.


For Gas Dryer, Check the following---


Note: Normal drying time for a dryer is about 45 minutes (some may take up to an hour).

1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

Jun 01, 2009 | Maytag Dryers

Not finding what you are looking for?
Amana DLE330RAW Electric Dryer Logo

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Amana Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Tim Whalen

Level 3 Expert

3069 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you an Amana Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...