HP 5610 all in one printer - prints "shadows" or "ghosts" after sled had jammed and was reset through a bit of force. t is mechanical rather than software related as it does the same with the direct photocopy function. If I draw a squigly line and photocopy it parts of the line are normal, and then othet parts have this shadow or ghost beside it. When printing on fast draft - what would normally be a straigt column of letters has some lines that shift to the right. ny help muchly appreciated! (when forced, the sled "clicked" upwards on the bar, the seemed to "click back" in place when I put it down again. This all stemmed from putting a cartridge in the wrong slot - duh!!!) Thanks - Tony
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This error message is displayed by the printer when paper is jammed in one or more locations. In such a case, users are recommended to remove the jammed paper from the specified location. The entire paper path must be checked for any pieces of paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor or sensor lever.