Question about Baby & Toddler Car Seats

1 Answer

Utility trailer electrical hook up to a dodge dakota 2005

I have been able to get all lights to work except the brake lights. would you have an idea how to get them to work

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 50 Answers

Try x ing out the the brake light switch on the brake pedal

Posted on Mar 31, 2008

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Just bought a 2005 smart cabriolet. I've had the top open a few times (without incident), but not fully open until tonight. When I went to close it, nothing happens. It makes a click in back, but the...

Hello :

If you think it's stuck because of some rust , then here is what to do :

first you need a doctor syringe filled with brake oil that you use for brakes . I need you inject this oil between and inside the joints of the door . Give it big loads .and let the oil get deep inside the joints
for a quite long time 3 or 4 hours or maybe more just to be sure .
Before you do that i need you to cover the seats with a big piece of plastic to protect them from oil drops . after a while just try to move it forward and backward to check if that worked . You need to be patient with that ..

good luck

rate if useful please !

Feb 20, 2010 | Smart Baby & Toddler Car Seats

1 Answer

Latch belt too short

Looked at the owner's manual of my car and realized where I needed to hook the latch belt hook strap. I was trying to hook it to the wrong thing. Car seat works great now!

Nov 21, 2009 | Safety 1st Baby & Toddler Car Seats

1 Answer

How do i install my electric seats in my rover 75 car

run a wire to power ( main wire) and hook the seat wire to it, but first make sure to fasten seats to the vehicle's floor

Sep 08, 2009 | Baby & Toddler Car Seats

1 Answer

Problem with break warning light

If this is the "brake warning light" as the subject of your post reads, it is telling you that the brake system pressure is low.

Check fluid in master cylinder reservoir. Then check for fluid leaks -- may need service.

I don't think your changing the bulbs and the brake warning light coming on are related.

May 05, 2009 | Maxi-Cosi Priori

1 Answer

2002 Cadillac Escalade

might have a stuck relay you could just pull it out and see if the heater turns off its on a diffarant line it the adjuster so the adjustment still works

Feb 14, 2008 | Baby & Toddler Car Seats

1 Answer

Wiring a trailer harness to a VW Golf Chico 2003 model

There are 4 pin up to 7 pin versions. There is alot of info here:  or

Feb 01, 2008 | Baby & Toddler Car Seats

1 Answer

Dachport problem {electronics shot}

Electrical problems are very difficult to solve on a car without the electrical diagram and the correct test equipment. It sounds like you have an "electrical short" which if not repaired correctly will result in having a "fire" and no car at all. I strongly suggest you take your car to a Ford Dealer and have them solve your problem.

Sep 16, 2007 | Baby & Toddler Car Seats

Not finding what you are looking for?
Baby & Toddler Car Seats Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Baby & Toddler Car Seats Experts


Level 3 Expert

3018 Answers


Level 1 Expert

7 Answers

Jennifer Rock
Jennifer Rock

Level 2 Expert

105 Answers

Are you a Baby and Toddler Car Seat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides