Question about GE Profile Spectra JGBP90 Gas Kitchen Range

1 Answer

Ge profile self cleaning oven

Do we use a cleaner on this or does it work by itself?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

Usually you would remove the racks and clean the food remaining on them and also the bottom of the oven before turning the self cleaning on.

Posted on Apr 08, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Check engine light was on in 99 Mercury Grand Marquis, went to autozone to run codes they came up as F1131 and F1151 which was for fuel injectors. I was told that Lucas Oil Fuel Injector cleaner would...


Gasoline itself a solvent, therefore its an excellent injector cleaner in of itself. No additives I have ever used worked, ended up replacing things anyway. Save some money, don't buy the lucas treatment, get some new injectors installed. Might not be a bad idea to change out your fuel filter also.

Nov 19, 2013 | Cars & Trucks

1 Answer

Radio won't turn on all the time. It works fine when it does. I cleaned the on off and it still does this. HELP


Try spraying electrical contact cleaner down the shaft of the on / off / volume control (after removing the knob itself) with the radio unplugged. Operate the knob if possible to "work" the cleaner into the mechanism - or gain access to the control from the back (inside) of the radio. These types of controls have an open snap action switch that is often piggbacked on the mechanism that may be visible or behind a tin protective cover. You may need to dismantle the cover to effectively flood the switch with cleaner. Read the label of the contact cleaner before using - as some may attack plastics, etc.

Good luck!

Feb 10, 2013 | Audio Players & Recorders

1 Answer

I recently brought out my vcr and am trying to clean it with Maxell VP-201 VCR pro head cleaner... but it doesn't say how to use it. Do you know where to apply the cleaner on the tape before I put it...


You can usually apply a couple of drops on the tape itself as it will not harm. The tape itself might have a hole located on the cassette itself close to the see through cover. We normal tell people to drop a couple of drops into the tape area

Jul 15, 2011 | Maxell VHS VCR Head Cleaner Wet Type 1...

1 Answer

2004 Dodge Durango. when started it idles high to 2000 RPMS then when on the road it stays at an rpm, you dont have to push the pedal it just goes by itself.


It sounds like the Idle Air Control Valve is stuck. This will give you a fixed idle it can stick at high idle or low or anywhere in between. If you take off the air cleaner you see where the air is getting sucked into a small slot or hole. spray some carb and choke cleaner in there let it sit for about 5 minutes then start the engine. spray a little at a time with the engine running till the idle comes down by itself. This should take about 2-3 minutes. If it wont come back on its own take the 2 torx screws out and remove it clean with carb and choke cleaner and replace. If it still fails it will need to be replaced. MOST of the time cleaning it will work

Jun 07, 2011 | 2004 Dodge Durango

2 Answers

My cd writer is not working can nort burn the disk what should i do i have a dell d800


Your cdrom drive can read a data disc or play cd audio? Check if its CDR/CDRW not DVDR/DVDRW, buy a disk cleaner and play it on your cd/dvd drive. After that try to burn again.

Nov 12, 2010 | Dell Computers & Internet

1 Answer

Burnt out part on mother board


Which board? There is one in the power supply that you plug into the wall and in turn plug the cleaner cable into. There is another that is not replaceable inside the grey or white colored motor assembly that is inside the cleaner itself.

If it is the one inside the power supply, there are several versions available. We can try to help you idnetify which one and quote you the replacement cost if needed.

Jun 08, 2009 | Dolphin Maytronics Diagnostic Robot...

1 Answer

Zodiac Pacer pool cleaner not sucking water or moving


Remove diaphragm and check for rips or tears in plastic.

May 31, 2009 | Zodiac Pacer Pool Cleaner

1 Answer

My car drives itself, revs high when in park to point of stalling


Bad or dirty IAC( idle control Valve) Romve duct work from air cleaner. Spray throttle cleaner or carburator cleaner with car running at about 1000 -1200 rpms . Aim straight at the IAC inside the throat of the throttle body. It is to the side of the throttle body . Try to aim at the hole and spary 10 seconds into the throttle body. Turn of the engine and let it sit for a few minutes. Then repeat the process. If that does not work, replace the IAC.

Jan 09, 2009 | 1985 Oldsmobile Delta 88

2 Answers

Numark cd mix 2


just clean the contact using the contact cleaner..remove the shuttle then spray the potentiometer..do not use the oil base cleaner!! look for quick dry non-residue electronic contact cleaner

Jan 21, 2008 | Nu Mark Numark Cd-Mix-2 Dual CD...

2 Answers

P850 shuts itself off for no reason


Try using a liquid contact cleaner. I read about this fix on another site, worked great for me.
A product called DeoxIT in the U.S. is what was suggested, I am in Canada and can't get that here so I picked up a product from a company called NexxTech. Just a liquid contact cleaner.
Take out the battery of the camera. Put a few small drops of the contact cleaner on the power button and let it drip down into the switch. Rotate the on/off switch back and forth 5-10 times, put the battery back in and Voila! Fixed!
No more random on/off irritations, camera works just like it did before the problem arose a few weeks ago.
It worked great for me.
Good Luck!

Nov 28, 2007 | Kodak EasyShare P850 Digital Camera

Not finding what you are looking for?
GE Profile Spectra JGBP90 Gas Kitchen Range Logo

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Ismael Rodriguez...

Level 2 Expert

162 Answers

 Fix Your Board
Fix Your Board

Level 3 Expert

310 Answers

Are you a Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...