I have vertical light patch on left handside of the screen

If the knocking sounds like thudding or something dull is knocking on the car, remove the left front wheel and check the drive shaft boot. It could have been torn and parts of it is hitting the lower arm. If it comes from the engine, check the engine mounts, all 3 of them.

what is the cause for the televisions screen to get white spots that spread

• Please pull the battery out and wait four five minets and see this may can help. Thanks!!!
  

most proboly your drum replace ur drum...or you can clean it first with windex..wait to dry (your drum is the shinny green things underneath your toner.) if that is clean replace your toner.

Try updating your display driver.

Generally the computer should be updated as far as the drivers is concerned.

Check on line at the website of this laptop for updated drivers.

Check these before you do anything else.

Hi, It seems you could be having a fuser problem if the line is running vertical all the way down. In that case you would have to replace the fuser to correct the problem!

Pick Patch Mode

Pick patch e.g. Moog Lead

On the Eidt Section of buttons: Parameters (click once)

This should show on the orange screen

PATCH l COMMON
NAME : MG Lead 1

then navagate using the right left buttons to

PATCH l COMMON
KEY MODE: SINGLE

Then press the split button (this is located on the right hand side of the board beside the ADSR pramaters) cick this until the light signifies that the board has been split aka the light beside the button is beside the word split

then navigate on the Orange screen to this

PATCHTONE (both)
NO.------MOOG

While on this screen press the upper/lower button on the right side of the synth.

this will then change the PATCHTONE (both) to PATCHTONE (upper) or PATCHTONE (lower) depending on what part you pick

then scroll through the tones you want for each part of the keyboard e.g. Tuba Left abd Trumpet right

Now what needs to be done is pick where the keys split e.g. C2 C3 C4 C5 or andy key on the keyboard not just the C's

PATCH l COMMON
Split point : C4

and then choose your split point

Now that youve finished you can save this setting for later playing. Navigate to:

PATCH COMMON
Write

pick your place on the keyboards memory I suggest one thats not already taken these are normally identified by this e.g. U00054

then click enter twice and you have yourself a nicely split keyboard! Enjoy!!!

11-08-07
I had the same problem with an etrex Vista. I spoke with Garmin, they said that a recently launched WAAS satellite is interferring with some models (he mentioned it is the models with a black and white screen). Garmin tech support said that they're working on a software patch but for the meantime switch WAAS off.

Call Garmin tech support with any questions or to find out about the software patch, 1-800-800-1020

When the call will be in progress u have to see on the right handside corner of the screen of ur handset, option of "loudspeaker" will be there OR u go to "options" on the left handside of corner of screen.Press it and loudspeaker will get activated.