Question about Keurig B100 Coffee Maker

Open Question

Check value and pump didn't do the trick

Eric, I pulled apart the pump, replaced the check valve, still no water dispensing. I am getting air through both, I put an egg cup with water and the hose from the top of the check valve into the water and get active bubbling during the cycle. What I did observe though, was a back wash of hot water coming from the very top hose coming from the water tank. It was about two tablespoons of water.  Any suggestions?? cheers, deb

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 13 Answers

SOURCE: Keurig B100 not pumping a cup of water through

in the water tank you have 2 sillicon tube one of them is stretch at maximum and usaly strech in 2. cut the part split and connect it again. the probleme is because the silicon left is propryety when is strech in very hot water. the best way to slove this problem is to find about 1 in of silicon tube of 1/4 or 3/16 iner and put the new parts of tube directly on the bafle and put the original tube in the new on. it just make a link betwen the bafle and the original tube. put teflon tape on the fitting of the bafle to avoid of the new tube spout out from the fitting.//// but take care and other touble can cause this the pump can be jam because the one way valve on the side of the brewer jam open because is to teith in in is body. check all is thing .if you need somthing eles y will comme back on the site soon :0)

Posted on Jun 17, 2007

Ad
  • 2042 Answers

SOURCE: B100 only dispensing 1tablespoon of water and drawer does not open

descaling with vinegar forget that you said after you decaled it it worst vinegar remove calcium in little chunks ckunks bloc everything use a special descaler it melt calcium just to prove you that im right you said you saw lime deposit if you use the descaler when the water come out no residue just water color change 1 part solution 1 part water put it in container start machine for few second stop leave it for 15 minute repeat untill empty that a hell of cleanup after dont forget to rinse that solution is very corosif cheers

Posted on Jan 26, 2008

  • 60 Answers

SOURCE: I have had my Keurig B60 coffee maker for over a

Valve is not bad that is not the issue you need to contact keurig to help you Call Keurig 1800 Cup Brew

Posted on Mar 23, 2010

  • 6 Answers

SOURCE: Keurig B2000 only dispensing 1/8 cup of water

call keurig....they will replace in a flash!

Posted on Sep 17, 2010

  • 2 Answers

SOURCE: the pump does not work

We had the same problem with our Platinum Keurig - the water would dribble out and stop before a full cup was brewed. It turns out the 3 openings to the upper needle were clogged (the Keurig specialist helped us). You have to pull off the little mushroom-shaped gasket first, then use a straightened paperclip and stick it into the 3 openings on three sides of the upper needle, moving it around for 15 seconds in each opening. Replace the gasket and then, by not inserting a k-cup, flush plain water through the needles for 3 different 6-oz brews (use a measuring cup to check). If you are still getting short-cups, you will likely need to call customer service. Make sure to clean the lower needle too - the instructions are in the book - but be careful not to break the funnel cover when removing. Good luck!

Posted on Jan 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Water won't dispense


Which pump did you replace? Are there a few?

May 13, 2013 | Electrolux 25.9 Cu. Ft. Side-by-Side...

1 Answer

Kenmore electric range gets a f1/f3 error code


The problem with the fabric softener not dispensing is not likely related to and F03 error code due to the washer not draining.

For the dispenser problem, I recommend that you pull the dispenser drawer out and clean it thoroughly.
The fabric softener dispenser works on a siphoning principle.
Make sure that the siphon hole in the dispenser is clear and not restricted or plugged.

You can fill the fabric softener compartment with water and make sure that it is siphoning properly while you are cleaning it.
Make sure that the cover is properly replaced on the fabric softener dispenser when the drawer is replaced in the washer.
You can use the diagnostic test described below to test the fabric softener dispenser.
If the softener dispenser does not fill and dispense properly, you could have a failed dispenser valve, a failed control board or a wiring failure between components.

You indicated that you tested the pump and that it is good. You could have a clogged drain hose or a clogged washer drain that would prevent the washer from draining.
You could also have a failed drain pump even though it runs. If the impeller is jammed or damaged, it will not pump out the water in the washer.
You will likely need to unplug the washer and drain the water out of the tub using a wet/dry shop vacuum.
To check the pump and drain hose at the bottom of the washer, remove the bottom front service panel and remove the drain pump. You may find a clog or restriction in the drain pump or connecting hoses. If the drain pump is damaged or will not work, it will need to be replaced.



Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Jun 10, 2010 | Kenmore Slider/Casement Air Conditioner

1 Answer

My brother moved and the movers removed the side by side doors


The dispenser assembly comes apart from the front. It should give you access to the waterline as it comes up from the bottom.
Eric

Jan 19, 2010 | Amana SXD524VW Side by Side Refrigerator

2 Answers

No Water from Door


Same problem with mine, no water, but could hear humming when pushing dispense lever. There is a coupler in the water line below the freezer door, I pulled it and opened it*, water came out when actuating the dispense lever. So it wasn't frozen between there and the wall, had to be frozen inside the freezer door. Solution? Turn off freezer side of the fridge and leave door open for an hour or two, voila, water in door again. *little blue coupler, push white collar in towards blue plastic to release line, push line back in all the way to replace it. This line has pressure only when dispensing water, and then not much pressure.

Dec 19, 2009 | Hotpoint HSS25GFP Side by Side...

1 Answer

Not getting water to icemaker;Water dispenser on door still working.Icemaker will go through process of dumping ice.No water leaks found.


3 steps: #1, check the fill tube for ice blockage,If not blocked- #2, verify there is power applied to the water valve when the IM cycles. #3 If yes replace the valve, If no replace switch in IM(complete faceplate in some models). Limited possibilities so elimination of what is working will locate the failure.
Eric

Dec 07, 2009 | Kenmore 55612 / 55614 / 5561 / 655619 Side...

1 Answer

Model#a4425gd2aww;water dispenser stays on witout pushing cradle even when ice selection is on. This is an americana refridgerator made by GE.


Disconnect the wires on the water valve.(or unplug the frig) If the water stops the dispenser control is defective. If the water continues the valve is stuck and needs replacing.
Eric

Oct 11, 2009 | GE (PSS26MSRSS) Side by Side Refrigerator

1 Answer

Ice maker works but water dispenser does not - replaced valves - pump, line is open ( blew air through it) all the way to the dispenser but it dows not pump water out


The water solenoid is working? Try switching the solenoids to see if this is the problem. The solenoids come completely apart and except for the body are interchangeable. (different size orafices) Mine was plugged with deteriorating rubber but this caused a leak at the dispenser. Worth a try

Sep 27, 2009 | Kenmore 55612 / 55614 / 5561 / 655619 Side...

1 Answer

Water dispenser is not functioning any longer for GD5RHAXNB00.


Check the reservoir behind the crispers to see if it is frozen. then check to see if the dispenser switch is sending power t the watervalve. If all these are ok then the problem is likely the valve.
Eric

Aug 27, 2009 | Refrigerators

1 Answer

No cold water


  1. Make sure filter is installed right.
  2. Disconnect water line see if water is flowing from line. May have a water valve in line not working.
  3. reconnect line but leave lose open inline valve just a little see if water flows out. No water PSI may be to low to reach up to fridge or valve stuck closed.
  4. Got water to connection tighten check dispenser for water.
  5. No Water If your system has a reservoir to store & chill water Your float may be stuck locate & check unstick if needed.
  6. Still no water May have faulty dispense value. Check value replace if needed.
Please rate hope this helped. If I can help further I'll standby.

Mar 09, 2009 | Samsung RS2534 Side by Side Refrigerator

1 Answer

Water dispenser...


I had the same problem, in reading a bunch of other similiar issues with various models, the best thing I found was that the water line inside the freezer door is frozen. I had to isolate this portion of my water line from the wall all the way through the frigde. It you unplug, take out screws from he back cardboard cover so you can follow the waterline through the fridge. The valves are pretty easy to take apart/put together. To take apart a valve, just press down on the ring around the valve the pull the connecting apart. To put back together, push the same ring down, then push the connection back together. To check the water flow, plug the fridge back in and have some one push the water dispenser as you check each valve. I suspect the problem is in the freezer door, so you should just check the valve under the bottom left side of the freezer door. From here to the dispenser the water line goes through the door. I used a blow dryer to heat up the inside of the freezer door just behind and below the dispenser unit for about 5 minutes. Try and run the water again and it should work. Good luck

Oct 07, 2008 | Kenmore 55612 / 55614 / 5561 / 655619 Side...

Not finding what you are looking for?
Keurig B100 Coffee Maker Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Keurig Coffee Makers & Espresso Machines Experts

Clayton McCune
Clayton McCune

Level 2 Expert

214 Answers

Lisa
Lisa

Level 2 Expert

101 Answers

Pierre Laplante

Level 3 Expert

2042 Answers

Are you a Keurig Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...