I have a Brother DCP-130C printer.
There was a printer jam, which has completely been cleared.
However I cannot print because an error code Print Unable 50 error appears or Clean error 50 or 30
I've tried EVERYTHING in the manual but no joy.
Is there a sequence of buttons I can press to clear this error?
No ;-)
The encoder strip switched off the ph and has to be set into place again.
see here how to fix it:
http://www.fixya.com/support/t211210-brother_mfc845cw
(enlarge the browser window to see pics somewhat better)
An advice:
when you have set the encoder strip in pos. again stick some scotch tape on the top of the ph cover where the strip runs thru to prevend the slipping off again on next paper jam ;-)
4,687 views
Usually answered in minutes!
Worked an absolute treat. Thanks VERY much.
Also put some electrical tape over the encoder strp, so will not happen again
Would never have known how to dismantle if it wasn't for these instructions!
brother printer error 50
×