I have small blue dots on the middle of my screen. It started out just a few but they are now all over the center part of the screen.Are there anything you can do to repair this problem?

The model indicated uses what is called a Optical Light Engine, it is a very expensive part and likely is your problem---not much else will cause this trouble.

Let me know if you have questions.

Sounds like a stuck pixel.

This is a defective Light Engine Assembly. The average cost to replace it is around $650.00

Defective light engine. I would start looking into a new set. Most DLP mfg's have stopped production because of new technology and high failure rate of the light engines. It's not worth the investment.....Sorry!

you most likely have a bad light engine.

Take a paper clip and unbend it. Then stick it in the small hole on the right side of the control panel. The machine will say please wait. after a few seconds you will see a small blue dot appear on the left side of the contol panel, (about middle of the screen) when you see the dot press the down the "3" button a screen will appear, select "Trouble Reset" once done machine will go thur its normal procedure. Once you have ready to copy, turn off the machine agian and turn it back on, if you don't the start button will be flashing continuously, If code comes back then the fuser is shot (Fuser is the hot section of the copier. which fuses the toner to the paper.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

check focus ic

http://www.sony.ca/view/319.htm

You will most likely need to replace the panel. You will have to contact Sony and they will send a Factory Trained Technician to your home to replace it. Since you are not on Factory Warranty this repair will cost you. You may find it cheaper just to replace the television.

need a new bulb