Question about Samsung lN-T406F 40 in. LCD HDTV

1 Answer

Takes 45 minutes to start

It's 19 months old. Started to take 5 minutes to start a 3 months ago
Now it takes 45 minutes, , , it just clicks

I read that it was 5 Caps that need to be replaced
that had to do with the Power Supply and that it is a Factory Defect
It's a shame that this had to happen to thousands of people
who bought Samsung.
I think I can take the back off and replace these parts if I had
them and with more detailed instructions
Please help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 87 Answers

Samsung will fix this for FREE, call them

Posted on May 12, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Microwave slow heating


It will need a magnetron and maybe a large capacitor soon

Nov 29, 2013 | Microwave Ovens

1 Answer

Jeep just clicks when trying to start


Sounds like your starter is not working,here's a link on how to remove,take to Autozone and they will test for free,takes only a few minutes.To check for power at starter,get meter and it should read 12 volts.

Mar 22, 2013 | 2002 Jeep Liberty

1 Answer

2003 mazda tribute, occasionally won't start. fuel pump replaced about 1 month ago. bad starter?


Many batteries may only last around three years. Check battery voltage at rest before starting. Any voltage in the low 12v range may be a sign of a faulty battery.If low voltage present, then perform a parasitic drain test:1) Disconnect battery POSITIVE terminal and connect ammeter in series, between battery positive terminal and positive lead.
DO NOT START THE VEHICLE!!

2) With all vehicle doors closed, alarm off, lights off, radio off, and all other accessories off, wait for around 20 minutes and then read the ammeter. A healthy system should read about 0.03 amps and little more. If reading more, then the vehicle could be suffering a parasitic amp drain, and you will need to locate this issue.


3) Reconnect battery when finished.


If no major parasitic drain present, yet low battery voltage then:


4) With vehicle started, check the voltage charge from the alternator. Connect voltmeter to battery terminals and take reading. A healthy system should be charging in the range of 14volts or down to around 13.5 volts. If reading around 12 volts only, then check and replace alternator.

Nov 03, 2012 | Cars & Trucks

1 Answer

I have an ACER5542 laptop, two days ago it started taking long to start up, all i see is a black screen. it takes about 3 to 5 times of turning off and turning before is actually comes on. the fan is...


hmmm If you leave it with a black screen does it eventually wake up?
think I would try reverting back to last restore point before the problem started then run antivirus software and as many system checks as possible. god luck

Also try removing power and taking out battery for a few seconds...sort of like the old reset ...have to do that every month or so on my old Aspire 4720Z...lol

May 24, 2012 | Acer aspire 5542 1615

1 Answer

The TV is less than 4 months old and problem started after first month. It powers off for anywhere 3 to 8 minutes. Vizio Logo is flashing until it powers up again. Last night it started after 45 minutes...


Take it back where u bought it exchange it for a new tv.This tv have a major issues,with the board that call the tv Tuner signal board.This is the board the take in the incomming broadcasting signal wire plug into this board to produce a picture out of the incomming broadcasting tv signal.

Apr 02, 2011 | Vizio M470NV 47 in. LCD HDTV

2 Answers

Since a month ago our dryer takes a long time to finish a load, A load which used to take 45 minutes to finish now takes close to 2 hours to finish.


check all of your duct work clean it out make sure there is no lint in the duct work going from the dryer to the wall also check the duct work going from the wall to the outside of the house

Dec 02, 2010 | Maytag Atlantis MDE7400AY Electric Dryer

2 Answers

Screen will not come on


If your screen is taking that long to turn it is a hardware issue with the screen and I would suggest contacting the manufacturer and try having them repair it at 18 months it still may be under warranty.

I hope this helped.

Thank you,
Norse

May 18, 2010 | Samsung SyncMaster 931B 19" LCD Monitor

3 Answers

Laptop overheating and shutting down


CPU IS OVERHEATING AND OVERWORKING MIGHT BE A VIRUS OR A HANING PROGRAM

Jan 20, 2009 | HP Pavilion dv8000z Notebook

1 Answer

No image but good quality speaker.


Sony has had a problem in older sets with-believe it or not- lack of humidity. I had one with the same problem. If it is under warentee take it back, if not-I know it sounds insane- put a large plastic garbage bag over the turned off set. Leave it that way for a couple of days. do not turn it on during this time. After a couple of days remove the bag and turn it on. If it works-that's the problem, if it doesn't- it's dying, and to expensive to fix. Surprised the heck outta' me when I tried it on my old Sony 19" set- it worked.

Jul 01, 2008 | Sony KP-46S25 TV

1 Answer

Is my Toshiba 57H81 worth repair?


Bounce horizontally usually means up and down,which relates

to the vertical output IC. Solder IC301, IC401 pin connects==try

again.You can easily isolate "bounce" problems by lightly

tapping on the vertical IC heatsink....Let me know if you need

further assistance.....T.

 

PS. Though hard to find, a qualified tech could do that repair

in home for 300. to 400.00...

Oct 20, 2007 | Toshiba 57H81 57" Rear Projection...

Not finding what you are looking for?
Samsung lN-T406F 40 in. LCD HDTV Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74106 Answers

Henry  Thomas
Henry Thomas

Level 3 Expert

1074 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1667 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...