Question about Canon Rebel XT / EOS 350D Digital Camera

1 Answer

Anything I can do for a flash busy error 99 message?

A few minutes after taking the battery (that just came off charge with a green light showing) and putting it in my canon xti and trying to shoot with it I get an error 99 message and the screen says that the flash is busy. I just took the battery off, the lens off, and the CF card out and I am letting it sit, but when I put the battery back on charge it showed a orange light like it was not fully charged. Could this be causing the problem. I have had the camera for 7mths now and I have not replaced the battery yet and I do use the camera quite often. Thanks for your help!
Tiffany

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,027 Answers

Could be that the battery is weak, and should be replaced as it is not holding a charge.

Posted on Jul 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fast flashing green light when trying to charge


usually fast flashing charge is faulty battery its trying to get volts in to the battery. you see the battery has a charging board on the battery not in the camera the camera sends the volts to the battery and the battery tells the camera its voltage, and when at the right volts stops charging. but these batteries can only be charged to around 10000hrs depending on the type of battery. you see when you get a new battery you need to charge it before use, now this can be 6hrs to 12hrs for fist time use if you interrupted the charge or have a power cut while it charges it can damage the charging chip in the battery. if this does the flashing light on other batteries then the signal is not being read by the camera and the camera can be faulty on the charging circuit, usually (sometimes) removing the battery for a few hours can fix this but it will rest the camera. hope this helps you.

Mar 24, 2014 | Nikon Coolpix S6300 Hd Digital Camera

3 Answers

Canon EOS Digital Rebel XTI 400D Displays Err 99. Problem with CF card. Replaced with brand new card-still same err 99 camera is totally charges, acts dead, keep flashing Err CF, I try to format, it...


Hi,

1. Turn off the camera.
2. Remove the lens, battery, and CF card.
3. Allow the camera to sit without power for approximately 20 minutes.
4. Insert a fully charged battery, and turn on the camera.
5. Depress the shutter button as you would to take a picture.
Does the “ERR 99′ message appear? If it does, then the camera should be
serviced. If it does not, then please proceed to the next set of steps:
1. Turn off the camera.
2. Insert the CF card.
3. Turn on the camera.
4. Format the CF card in the camera.
5. Depress the shutter button as you would to take a picture.
Does the “ERR 99′ message appear? If so, then the CF card is the most
likely source of the issue. Try using a different card.
If the message does not appear, please complete the following steps:
1. Turn off the camera.
2. Clean the lens contacts by gently rubbing them with a pencil eraser
or soft cloth. Be careful that you do not let any debris fall into the
camera body.
3. Reattach your lens.
4. Turn on the camera.
5. Depress the shutter button as you would to take a picture.
If the “ERR 99′ message only appears when one particular lens is
attached, then that lens should be examined by a service technician.
If you see the “ERR 99′ with a different Canon lens attached, then the
camera should be serviced.

Aug 31, 2008 | Canon EOS-20D Body only Digital Camera

1 Answer

Error 99 keeps coming up I reload the battery turn on off but after a few shots it comes up again and the red shows indicating that it is still processing the shot.


Here is the diagnostic process, allegedly from Canon themselves. It's quite old, a newer camera probably has a SD card rather than CF.

To isolate the cause of the issue, we [Canon] suggest that you do the following:

1. Turn off the camera.
2. Remove the lens, battery, and CF card.
3. Allow the camera to sit without power for approximately 20 minutes.
4. Insert a fully charged battery, and turn on the camera.
5. Depress the shutter button as you would to take a picture.

Does the "ERR 99" message appear? If it does, then the camera should be serviced. If it does not, then please proceed to the next set of steps:

1. Turn off the camera.
2. Insert the CF card.
3. Turn on the camera.
4. Format the CF card in the camera.
5. Depress the shutter button as you would to take a picture.

Does the "ERR 99" message appear? If so, then the CF card is the most likely source of the issue. Try using a different card.

If the message does not appear, please complete the following steps:

1. Turn off the camera.
2. Clean the lens contacts by gently rubbing them with a pencil eraser or soft cloth. Be careful that you do not let any debris fall into the camera body.
3. Reattach your lens.
4. Turn on the camera.
5. Depress the shutter button as you would to take a picture.

If the "ERR 99" message only appears when one particular lens is attached, then that lens should be examined by a service technician.

If you see the "ERR 99" with a different Canon lens attached, then the camera should be serviced.

Jan 19, 2011 | Digital Cameras

2 Answers

'busy' message in view finder won't take a picture


how can you download and update firm ware when you cannot see anything on the screen?!!!!

Apr 07, 2010 | Canon EOS Digital Rebel XS / 1000D IS...

1 Answer

Canon Rebel XT wont fully come on


Hi

Error 99 is usually a lense error and gives the only real clue as to what is going on with your camera. You can try this simple fix which comes straight from Canon. Follow the steps to help isolate the issue. Note the fact that you are currently not getting the Error 99 is probably a good sign according to the troubleshoot.

To isolate the cause of the issue, we suggest that you do the following:
1. Turn off the camera.
2. Remove the lens, battery, and CF card.
3. Allow the camera to sit without power for approximately 20 minutes.
4. Insert a fully charged battery, and turn on the camera.
5. Depress the shutter button as you would to take a picture.
Does the “ERR 99′ message appear? If it does, then the camera should be serviced. If it does not, then please proceed to the next set of steps:

1. Turn off the camera.
2. Insert the CF card.
3. Turn on the camera.
4. Format the CF card in the camera.
5. Depress the shutter button as you would to take a picture.
Does the “ERR 99′ message appear? If so, then the CF card is the most likely source of the issue. Try using a different card.
If the message does not appear, please complete the following steps:

1. Turn off the camera.
2. Clean the lens contacts by gently rubbing them with a pencil eraser
or soft cloth. Be careful that you do not let any debris fall into the
camera body.
3. Reattach your lens.
4. Turn on the camera.
5. Depress the shutter button as you would to take a picture.
If the “ERR 99′ message only appears when one particular lens is
attached, then that lens should be examined by a service technician.

If you see the “ERR 99′ with a different Canon lens attached, then the
camera should be serviced.

Hope this helps. Please do rate my answer. Thanks.

Aug 09, 2009 | Canon Rebel XT / EOS 350D Digital Camera

2 Answers

Canon 450D, ERROR 99 only when flash pops up


Err 99 usually means your lens contacts are dirty either on the lens itself or on the camera.

To isolate the cause of the issue, do the following: -
1. Turn off the camera.
2. Remove the lens, battery, and CF card.
3. Allow the camera to sit without power for approximately 20 minutes.
4. Insert only a fully charged battery, and turn on the camera.
5. Depress the shutter button as you would to take a picture.

Does the “ERR 99" message appear? If so, the camera may be faulty and requires a service. If it does not, then: -
1. Turn off the camera.
2. Insert the CF card.
3. Turn on the camera.
4. Format the CF card in the camera.
5. Depress the shutter button as you would to take a picture.

Does the “ERR 99" message appear? If so, then the CF card is faulty. Try a different card. If the message does not appear: -
1. Turn off the camera.
2. Clean the gold contacts on the lens by GENTLY rubbing them with a pencil eraser or soft cloth. Keeping the camera face pointing down, also clean the gold contacts on the camera, being careful that you do not let any debris fall into the camera body.
3. Reattach your lens.
4. Turn on the camera.
5. Depress the shutter button as you would to take a picture.

If the “ERR 99" message only appears when one particular lens is attached, then that lens should be examined by a service technician.
If you see the “ERR 99" with a different Canon lens attached, then the camera is faulty and should be serviced.

Mar 31, 2009 | Canon Rebel XT / EOS 350D Digital Camera

1 Answer

Err CF then Err 99 - Canon Rebel XT / Hitachi 4GB Mircodrive


Not all CF cards are created equally, so yes, it could be your batch of cards. To determine if the error is CF related, and not anything else, try the following steps which are used to diagnose err 99's

To isolate the cause of the issue, do the following: -

1. Turn off the camera.
2. Remove the lens, battery, and CF card.
3. Allow the camera to sit without power for approximately 20 minutes.
4. Insert only a fully charged battery, and turn on the camera.
5. Depress the shutter button as you would to take a picture.


Does the “ERR 99′ message appear? If so, the camera may be faulty and requires a service. If it does not, then: -

1. Turn off the camera.
2. Insert the CF card.
3. Turn on the camera.
4. Format the CF card in the camera.
5. Depress the shutter button as you would to take a picture.


Does the “ERR 99′ message appear? If so, then the CF card is faulty. Try a different card. If the message does not appear: -

1. Turn off the camera.
2. Clean the gold contacts on the lens by GENTLY rubbing them with a pencil eraser or soft cloth. Keeping the camera face pointing down, also clean the gold contacts on the camera, being careful that you do not let any debris fall into the camera body.
3. Reattach your lens.
4. Turn on the camera.
5. Depress the shutter button as you would to take a picture.
If the “ERR 99′ message only appears when one particular lens is attached, then that lens should be examined by a service technician.
If you see the “ERR 99′ with a different Canon lens attached, then the camera is faulty and should be serviced.

Feb 13, 2009 | Canon EOS 30D Body Only Digital Camera

1 Answer

My canon 20d stopped taking photos for no aparant reason. Kept getting error 99 and when I re insert the battery it starts clicking on it's own whether turned on or not. I sent it to Canon repair who...


If two cameras are doing it, I would suggest the contacts on your lens are dirty.

Try the following diagnosis steps for solving ERR 99 issues : -

To isolate the cause of the issue, do the following: -
1. Turn off the camera.
2. Remove the lens, battery, and CF card.
3. Allow the camera to sit without power for approximately 20 minutes.
4. Insert only a fully charged battery, and turn on the camera.
5. Depress the shutter button as you would to take a picture.

Does the “ERR 99" message appear? If so, the camera may be faulty and requires a service. If it does not, then: -
1. Turn off the camera.
2. Insert the CF card.
3. Turn on the camera.
4. Format the CF card in the camera.
5. Depress the shutter button as you would to take a picture.

Does the “ERR 99" message appear? If so, then the CF card is faulty. Try a different card. If the message does not appear: -
1. Turn off the camera.
2. Clean the gold contacts on the lens by GENTLY rubbing them with a pencil eraser or soft cloth. Keeping the camera face pointing down, also clean the gold contacts on the camera, being careful that you do not let any debris fall into the camera body.
3. Reattach your lens.
4. Turn on the camera.
5. Depress the shutter button as you would to take a picture.

If the “ERR 99" message only appears when one particular lens is attached, then that lens should be examined by a service technician.
If you see the “ERR 99" with a different Canon lens attached, then the camera is faulty and should be serviced.

Dec 14, 2008 | Canon Rebel XT / EOS 350D Digital Camera

4 Answers

The battery wont charge


i had the same problem.

if your battery light is blinking a red light then you should call up casio's technical support and they'll send you a new one within 2-5 business days:)

call 1-800-435-7732 for technical support! :)

Apr 01, 2008 | Casio Exilim EX-Z77 Digital Camera

2 Answers

Error 99 only when flash pops up


I know what you two are talking about. I ordered a Canon EOS 300d from a site called "Keh" and I had never used one before... so I get it in the mail on time. The camera works fine for a few minutes then I get an "error 99" and can't do jack with the camera. I researched online and even called keh ... I read and heard that it has to do with the lens... so I sen't the camera back and got my money.

Nov 26, 2007 | Canon Rebel XT / EOS 350D Digital Camera

Not finding what you are looking for?
Canon Rebel XT / EOS 350D Digital Camera Logo

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Canon Digital Cameras Experts

Doberman

Level 2 Expert

246 Answers

Tony

Level 3 Expert

2598 Answers

halotheracer
halotheracer

Level 2 Expert

68 Answers

Are you a Canon Digital Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...