Question about Proscan PS27108 TV

2 Answers

No Sound, No Picture

We were watching t.v. last night and the t.v. just completely went out, tried to unplug to see if we plug it back in would it start, it did not. No sound or picture. What do you think

Posted by on

  • 3 more comments 
  • scaler50 May 18, 2008

    it was working last night and this morning nothing,tv won`t power up

    not even a click



    rca proscan ps27108

  • Anonymous Jul 27, 2008

    no power fure OK

  • gilbertcharl Dec 20, 2008

    i have the sam problem my chassis no. is CTC187BF/ model PS27108

  • Norm Alexander Jan 20, 2009

    I have the identical problem, no picture, no sound, no signs of life.

  • tbgoode01 Apr 05, 2009

    have rca home theatre model p52813bl. wnet out,will not come back on

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 99 Answers

Is there a ruster in the screen or snowy?,if none,try to check the fuse,it might blown,or defective ,check if there is a continuety using the vom tester if no continuety replace with the same value.of ampheres.

Posted on Mar 29, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 149 Answers

Do you have chassis number example ctc195 or CTC203 find out an let me know email me

Posted on Mar 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Was working fine last night ,went to turn it on and you can hear a buzzing by where you plug in your jacks a bee,or high pitch sound.tv has no picture or sound.only sound you hear is this buzzing



Sounds like your power supply is causing the problem. Unplug the TV wait 10 minutes, look in the back for a red button (circuit breaker) push it in. If this does not work you have a low voltage power supply fault.

Mar 04, 2016 | Standard (CRT) Televisions

1 Answer

Last night about 3 am I turned off my tv. when I usewd my remote to turn it back on it would not ( t v) come on and no picture or sound . I turned it around to see the back of it but it has no reset


Your TV have faults on Horizontal deflections, the oscillator and the Flyback might be the problems. If you are not familiar with TV circuits?... call tecnician to check your set.

Oct 03, 2014 | Standard (CRT) Televisions

1 Answer

My sony trinitron is blinking red and won't turn on


THIS IS NORMALY CAPACITORS IN THE POWER SUPPLY THAT NEED REPLACING

Jun 25, 2013 | Sony FD Trinitron WEGA KV-34HS510 34" TV

1 Answer

Sylvania SRT2232S Powers On, No Picture, High Frequency squeal


Hello there. I'm sorry to say that it sounds as if the element that actually energizes your screen is bad. It is most likely overheating. or quite poosible the power converter lost a resistor or 2.

Nov 27, 2008 | Sylvania SRT2232S 32" TV

1 Answer

Tv no pic or sound


If you hear the high voltage try to come up and set shuts down in 2 secs it could be your FBT also these sets have alot of poor connections chassis should be resolder.

Apr 06, 2008 | Standard (CRT) Televisions

1 Answer

Black Screen


The first step here is to isolate the problem. You need to know if it is in your TV or DVR. Unplug your TV from the DVR and connect it directly to the wall outlet. Then connect a TV antenna, or a small thin wire, to the F connector on the back of the TV (this is the threaded connector - where you plug your cable). Try searching for some air channels and see if you get any channels at all, and post back.

Feb 26, 2008 | Apex Digital AT2708 27" TV

1 Answer

No picture but sound works.....


  • adjust brightness setting when playing tv.
  • adjust screen control located on flyback transformer.
  • hope this will help.

Oct 23, 2007 | Sony KV-36FS16 36" TV

4 Answers

TV WENT OFF BY ITSSELF


This may denote a proble in either your switching powers supply or your Horizontal section derived high voltage power supply. These are both very dangerous sections in your television. My next question is important; do you have a background in electronics? If not I would not advise you working on this problem yourself and that you take the TV to a repair shop for servicing. If you do have some background in electronics, I would like for you to make the following obeservations: What was the TV doing (it actions)prior to it going out? Did you hear any sounds before it went out like buzzing or crackling? What do you hear when you try to turn it on now, clicking? These questions are just to develop some background into what might be happening to your set. Thank you, Shuttle83

Oct 07, 2007 | RCA 32V524T TV

1 Answer

TV went out


Hey Jim, The high voltage protection circuit has gone out on the D-board and will need to be replaced. The fuse to the power supply is probably fine. A good repair tech shouldn't charge over $125 for this and it only takes a couple of hours. Let me know if I can be of further assistance.

Jul 17, 2007 | RCA F27242GY 27" TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Proscan Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68157 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Cindy Wells

Level 3 Expert

4751 Answers

Are you a Proscan Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...