Question about Garden

1 Answer

My stihl fs36 Whippersnipper continues to flood what is the cause

My Stihl FS36 Whipper snipper continues to flood What is the cause?

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 7,482 Answers

Your float adjustment in the carb needs to be reset, or there is trash under in inlet valve in the carb.
If the float is set wrong or trash in the inlet valve then that will cause the problem of flooding,
Sounds like you will need to clean your carburetor.
Sometimes you can get by with priming it a few times, and letting it
run a few times like that and it will flush the gunk out of the jets,
but most of the time you will need to rebuild the carburetor.
If the mower is over a couple years old, then I also recommend that you
buy and install a new carburetor repair kit, because the diaphragm will
get hard and that will cause it to be hard to crank.
When you clean your carburetor and remove the jet screws, count the
number of turns it takes to seat the jets from their original position.
That way when you go to put the jets back in, you know how many turns
they were in/out.
Please rate me, Thanks
Good Luck, I hope this helped

Posted on May 15, 2010

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: my stihl fs36 Whippersnipper continues to flood what is the cause

needs a carb kit with needle valve $20 at a small engine store

Posted on May 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My still fs36 whipper snipper runs but wont rev out


The strimmer has a small engine and therefore very small fuel passages that are very easily blocked unless a near-surgical cleanliness is observed when fueling and the air cleaner maintenance is up to date and carefully carried out.

In my experience such fuel-related problems are most likely. It is worth checking the spark plug first considering how much easier that would be. In the case of a blackened condition begin by checking the air cleaner for fouling and the cold start for correct operation.

Jul 17, 2015 | whipper snipper Garden

1 Answer

Stihl fs 35 recoil


Stihl don't make an FS35 but they do make a FS36
this should help.
http://www.mediafire.com/view/yleara73l4w78xa

Jul 07, 2014 | whipper snipper Garden

1 Answer

Stihl whipper snipper fuel oil ratio


all Stihl products are 50:1 fuel mixture

Mar 30, 2013 | whipper snipper stihl fs 38

1 Answer

Fs44 whipper snipper recoil spring unwound, cord jammed and when tried to release recoil spring released


Its an easy opperation to undertake if you know how. Take note of where everything goes during the stripping down of the recoil assembly. Use eye protection when trying to recoil the rewind spring, they have a tendency to jump back out at you while coiling them back in. easiest way is to start by putting the hooked end into the plastic housing and work your way inwards coiling it back in. Then place the starter cord roller in on top, adding the one or two black sliders, the washer and the spring clip to hold it all in place.
http://rapidlibrary.com/source.php?file=ulztcbvqczi89on&url=http%3A%2F%2Fwebweevil.co.uk%2FPublic%2FInfo%2FStihl%2520FS36%252C%2520FS40%252C%2520FS44%2520parts%2520list.pdf&sec=a0a080fc8669d51a

The link is for the breakdown manual and parts list

Feb 16, 2013 | Stihl Trimmer Oe Rewind Starter Spring 36...

1 Answer

Where do I attach the stop switch wire on a Stihl FS36 weed trimmer?


one end goes to the switch the other end goes to the ignition module

Jan 04, 2013 | Stihl Fs36 Line Trimmer Gas Tank

1 Answer

Need a diagram for fuel line placement on Stihl FS36 line trimmer


Hi Lee Miller
Hope this is what you need
Please take time to rate me
Bud
10_19_2012_1_59_16_pm.gif

Oct 18, 2012 | Stihl Walbro Wt-160b Carburater For An...

1 Answer

I need to see a fuel line diagram for Stihl fs36 trimmer


Hi Lee Milleer
I hope this is what your looking for
Please take time to rate me
Bud
10_19_2012_1_55_26_pm.gif

Oct 18, 2012 | Stihl Fs36 Line Trimmer Gas Tank

1 Answer

What is the airgap for the magneto on a stihl fs36


normally .16 or a match book cover between the two would work.

Mar 27, 2010 | Garden

1 Answer

My stihl fs36 Whippersnipper continues to flood what is the cause


needs a carb kit with needle valve $20 at a small engine store

Mar 17, 2010 | Yard Machines Garden

Not finding what you are looking for?
Garden Logo

Related Topics:

664 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

john h

Level 3 Expert

12104 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...