I need a manual for RS 140 head phones - Sennheiser RS 140 Consumer Headphones

ck that batteries are installed correctly and contacts are clean. Put the old batteries in, if it is not trying to charge them, sounds like the charger is bad.

so dear, their is a problem with the charging pin of your mobile, since you always insert different chargers to your mobile!
or their must be a little short circuit in your mobile circuit because of using different local charges..
introduce your phone to a repairing shop he will make it at very less and nominal charges, nokia charging pin cost rs.140 then he will take his service charge.

regards!

http://www.jntworld.com/catalog/index.php?cPath=21_1002&currency=gbp&osCsid=c5b2f0de48c59564afb36dfebba513ac#tabbed_box_1

Here you will find something.

Here is the link to the user manual:
http://www.sennheiserusa.com/media/productDownloads/instructionManuals/RS140_Instructionsforuse.pdf
thank you,
Lee

• SWITCH OFF UR HEAD PHONE BH 140
• THEN ON AND LONG PRESS ON OFF KEY IF LIGHT WILL STOP THEN SEARCH BLUETOOTH WITH UR PHONE
• IT WILL SEARCH UR H.P. BH 140
• SUCCESS RESULT
• IDRISH 911

Seriously at 140 KPH you should be going about 4200 RPM in 5th gear -your red line is about 8000 RPM so unless you weigh 400 pounds or are pulling a trailor your fuel system or electronics are screwed up. Could also be old gasoline plugging injectors ( try a tank of techron from Chevron)........Jack in Surrey

At least 140 bar, if lower than 130 then the engine top-end needs inspecting to investigate for damage
The easiest way is to remove the exhaust & shine a light into the cylinder, then you can tell the condition of the piston outer & cylinder liner inner.

Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)

P.S. I'm available for 'Live Chat' now

that year (1991) only had a 2.2 and a 3.1 L motor VIN (T) according to my manual be that as it may
Horsepower @ RPM was 140 @ 4800
Torque @ RPM was 180 @ 4800

Robert

Yes, you may. RCA connections are universal, just don't connect an input lead to an output jack: you might damage the jack.