I have an HP copyer 290, it is showing me that scanner failure

30.03.23 Scanner calibration failure - HP Support Community

https://h30434.www3.hp.com > LaserJet-Printing > td-p
Oct 2, 2017 - Error message: 30.03.23 Scanner calibration failure on HP Color LaserJet MFP M680 I have: 1. Turn off the printer 2. Update firmware 3. Restarted - 6354400.

• 
  

  30.03.23 error ' HP® Customer Support

  https://support.hp.com > ca-en > document
  When a 30.03.23 Error Alignment Calibration Failure appears on the control panel, it indicates there is an issue calibrating the scanner.

HP LaserJet Enterprise MFP M630 - 30.03.23 - Printcopy.info

https://printcopy.info > brand=HP > code=30.03.23
Code: 30.03.23; Display: 30.03.23 Scanner failure; Description: Flatbed alignment calibration error. Remedy: 1. Turn the product off, and then on again. 2.

Thanx for contacting in fixya....

u need to uninstall the printer software and then reinstall if this problem persists again format ur system c driver it is the only sure solution


regards
john symester

Use another Bootable Disk Operating System to see it as may be the same problem you have. I think it's your Installer Disk have a problem.
From this problem it's windows system failure to show display appearance normally.
At least you try just one installing another Bootable Disk.
Good luck!

Fault connected with feeding the current or controller, main of the processor, you should apply to service, this difficult fault

52 error are error in printer scanner not in the copyer scanner..
replace the scanner inside the printer..

Clean Scaner Unit Properly its not easy to done
other wise all engineer

Hi..

if the scanner bulb is not moving, then its an hardware problem.
We can try by resetting the printer.

POWER DRAIN:-Turn off the printer, Unplug the power cable from printer and from the wall outlet.Press and hold ON buton for 30-60 seconds.


PARTIAL RESET:-Unplug the printer power cable while its ON, press and hold # and 3 button and connect the Power cord while holding.Wait untill the ON light flashes, then release the buttons.

----(for below reset cartridges must be removed out)---------

SEMI_FULL RESET:-Unplug the printer power cable while its ON, press and hold # and 6 button and connect the Power cord while holding.Wait untill the ON light flashes,or wait for 20 seconds,hen release the button.If the printer goes off dont worry release the button and Push the ON button.


FULL NVM RESET:-Take the Ink Cartridges out, Unplug the printer power cable while its ON, press and hold OK/ENTER and CANCEL button and connect the Power cord while holding the buttons.keep Holding the buttons until the printer goes off ,release the button and Push the ON button.

(Notes - resets will take a while)

Please let me know after resetting.

Thank U!!

scanner failure, turn unit off and back on, does not help

I lost the disk of my printer scanner copyer HP PSC 1410 I want to install and use it Can you arrange for me?

I have been finding that scanner failure when the light is still working is usually a dirty scanner. Disasemble and clean the mirrors with windex. No job for a novice, but what have you got to lose at this point.