Camera when i install my camere a high speed usb is plugged into a non high speed appears

Presumeyou should install drivers. you shold ask for helf from the provider.

Try NOT connecting your camera to your computer.

The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.

Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use Nikon Transfer or any other photo cataloging program.

You can download the current versions of all (free) Nikon software from
http://support.nikontech.com/app/answers/detail/a_id/61

Please get it downloaded here : www.givemefile.net > ... > Camera & Foto > Digital camera
www.jvc.com/
www.helpdrivers.com/cameras/JVC/

Best regards

if you run vista it will not recognise the drivers, you will need to download an update from HTC or from your mobile operator.
faling that check microsoft vista website for mobile device software- vista does not use active sync

• Normally you would connect the camera to the pc using a USB lead. To do this your camera should have a mini USB slot somewhere and you would plug the mini USB cable plug in to this, then plug the larger USB end of the cable into one of the USB ports on your PC (USB ports are usually oblong and situated on the back of the PC) , You may need to install some software supplied with the camers to do so.

Please remember to rate this solution.

To view the pictures on the computer, remove the card from the battery compartment and put it in a card reader connected to your computer.

Dear customer,

Though you get these msg's which you have mentioned, you can ignore them, and try manualy installing the driver software for the camera, somehow.

Thankyou

Your problem has been addressed by microsoft itself. and it is available at the following link. http://support.microsoft.com/kb/927836 If you have the manual refer to it and find out the USB version it requires and See the BIOS setting for USB.(High speed/Full speed) Some cameras only support USB 1.1 it will not work with other high speed USB. this can be modified through some BIOS settings for e.g. "USB 1.1/USB 1.0 comaptibility mode -> Enabled" Also make sure that you installed the latest drivers for your USB ports.

Sir you must use the right USB cord for your Sansa!