Question about Kenwood KDC-MP4032 CD Player

1 Answer

The dispaly screen is blank but the volume and control knobs light up

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 17,970 Answers

Check the resistors, are on the board and they are big, re-soldered the resistors and sure enough the display works again.

I read this similar post in displays is out.

Good luck.

Posted on May 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Displays is blenk


if the display is totally black the cause is either dead back light or the power inverter get bad. if has a white screen but no picture it was a lcd controller board problem.

Oct 23, 2012 | Computers & Internet

1 Answer

Phone seems to work, but has a blank screen


i think its display problem.. check the display once... or take a new dispaly

Nov 20, 2009 | Nokia 6300 Cellular Phone

1 Answer

Screen is blank - at power on sceeens flash screen


there is no signal coming in from graphics card. please check graphics card.

Nov 01, 2009 | ASUS P5GC-MX/1333 - Motherboard - micro...

1 Answer

Compaq screen goes blank after power up?


When yo upower up press F! or F2 or "del" key to enter in bios then check your harddisk is detected? if your harddisk is sata then enable sata option in bios then save settings.
If every thing is fine then it should be dispaly resolution issue.
When yo upower up vthe computer press F8 key then enter in enable vga mode then go to control panel then dispaly proeprty-> settings ->change screen resolution to 1024*768 then restart .

Thanks for using fixya.
Please rate this solution if it helps you.

Jul 27, 2009 | Acer 91.63X07.001 Keyboard

1 Answer

The knob is malfunctioning


The flex that controls the volume on it is broken it is a strip that has wires to it.

Apr 23, 2009 | Dual XDMR7710 CD Player

1 Answer

Volume control knob on radio turns volume up at all times


first of all if you live in a cold climate I never turn the radio on until the car warms up if you can remove the knob on the radio spray a light amount of WD 40 and then put the knob back on and turn it back and forth and if you have pop on your hand or water also dry your hands off before touching the radio the lights and the radio will last a lot longer also and also before leaving the car always remember to turn the radio off it will be alot easier on your battery as well

Jan 05, 2009 | 1998 Pontiac Bonneville

1 Answer

White display error for some time of perod in omni900 book


change dispaly in control anel dispaly screen resolution to 1024*768
type in run "control"

Jan 01, 2009 | HP Pavilion dv2742se Notebook

2 Answers

Volume knob


I contacted Jensen and got a real soluton without paying you anything....and it didn't cost me one dime!!!!

Oct 05, 2008 | Jensen MP5720XM

1 Answer

Display


go into your tools menu by pressing the center of the multi knob.(the volume control knob) turn same knob to bring up the entertainment field, press center of knob to set then turn till you get to the prompt about alternating screen. switch to no. done.

Apr 06, 2008 | Pioneer DEH-P790BT

Not finding what you are looking for?
Kenwood KDC-MP4032 CD Player Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenwood Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4834 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Kenwood Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...