Question about GE 7-4853 Clock Radio

1 Answer

Can't turn off the alarm

Can't turn off the allarm

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

There are two alarms, and the steps are the same .
Look on the face. On the left of the big numbers are two symbols, a 'bell' and a 'music note'. That's WAKE 1. On the right of the big numbers are two symbols, a bell and music note. That's WAKE 2. If any of these are on, then one (or both) alarms are set to repeat.
Stopping repeat Wake 1 alarm. Click the Wake 1 button (on the top) several times, while looking at the face. Notice the circles that light up. It will switch back and forth between bell and music note each time you press the Wake 1 alarm button.
HOLD DOWN the WAKE 1 button on the top, until both lights are off. The Wake 1 alarm is now off.
Wake 2 alarm: Same steps, but for the green circles on the right side of the face.

Get a piece of paper, write "HOLD DOWN WAKE BUTTON to stop repeating alarm" and tape it to the back of the clock.

Posted on Sep 18, 2010

  • granny2annie Dec 06, 2010

    this was very helpful..thank you

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i disarm my allarm on my 199volkwagon passat


If the alarm it's the factory you just need to use your key and unlock the car from the driver side and should do it , if is after market you must disconnect one of your battery post turn the key to on position and then reconnect the battery

Apr 04, 2013 | 1999 Volkswagen Beetle

1 Answer

Battery ran flat on my 'R' reg VW Golf gti while I was away in Australia. The alarm was disconnected a couple of years ago but now the immobiliser seems to have triggered as there is no spark or petrol...


sometimes it depends on the type of allarm, if it is factory fitted they are a nightmare to do as most of the wireing for the allarm is intergrated into the loom, where as if it is an after marked alarm ( one fitted later on ) it shouldnt be to bad but still a long and complicated job to find all the wires and reconnect the originals bypassing the immobiliser/alarm if you are a complete novice this should not be attempted as you could immobilise the car completely, best thing for you to do is get an auto electrician to have a look at it for you, sorry its not much help

Feb 15, 2010 | 1999 Volkswagen Golf

1 Answer

I am unable to lock my car without the alarm going off!


it is some component or reciever in the car that recieves the signal of the allarm button or whatever is messed up or malfunctioning of course.

Nov 29, 2009 | Vehicle Parts & Accessories

1 Answer

Newly installed car alarm, LED in solid light n horn/siren blares


if you follow instruction properly than the alarm should work properly, Go over your wiring again 2-3 times make sure it make sense to you with the instructions. If it make sense than take the unit back and get another, can be faulty alarm.

Aug 26, 2009 | 2003 Toyota Corolla

1 Answer

How do i disingage the allarm system so I can


Try to locate the fuse and remove it or the power wire hot from batt.

Aug 16, 2009 | Nissan Pathfinder Cars & Trucks

1 Answer

Jetta


Some of the alarms have a built in fuse you could pull out while others get power through a fusible link. I would suggest finding out how the alarm is receiving it's power and disconnect it from power..

Jul 02, 2009 | 1997 Volkswagen Jetta

1 Answer

Antivirus zone alarm


hi pc it could be one of two things your zone allarm may be set up to check for new version of zone allarm and if it you want the lattest version then it's safe to accept the pop up, or it may simply be an undate for zone allarm also safe, provided it comming from zoneallarm your ok.

Oct 08, 2008 | Computers & Internet

2 Answers

Alarm


that does sound like a memory issue. remove the memory and reinstall it to make sure it is seated properly.

Robert

Sep 06, 2008 | Compaq Presario SR1050NX (DW257A) PC...

Not finding what you are looking for?
GE 7-4853 Clock Radio Logo

Related Topics:

387 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Audio Players & Recorders Experts

Greg Cann
Greg Cann

Level 3 Expert

1114 Answers

Jonathon summesfield

Level 2 Expert

285 Answers

Carlos L. Burgos
Carlos L. Burgos

Level 2 Expert

619 Answers

Are you a GE Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...