Question about Sony SDM-HS73P 17" LCD Monitor

1 Answer

Monitor black screen

Hi i read one of your posts about the LHS73K V1.2 being the dead chip and you can get a v1.3 chip and replace it and it will work
well i was wondering ware i can purchase one of these so i can get this sony monitor working instead of using my hd tv as my monitor haha if you could help me out id greatly appreciate it

russ

Posted by on

  • carlosrh Mar 27, 2008

    my PC uses Vista Basic. Screen go black since beginning. Anti-virus AVG Free edition is updated. Toolbars at base of monitor show up and when I click on them they become active. I can use Internet and all my programs. I use Webshots slide show and can be handled OK manually. I can use most of my programs but I can not see the icons on the screen because is all black, Because of all that I have mentioned I don´t think is the monitors but rather a software problem. Can Anyone help?

    Thanks,,,,

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 180 Answers

Try asking from your nearest service centre .

Posted on Apr 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WANT TO UPGRADE FIRMWARE. SCREEN GOES BLANK


Allways read about the serial number before flashing firmware or the wrong firmware revision was loaded for this model ?

firmware chip replace by new or lend a chip with an appropriate revision start and create a hot-swap by reinserting the old chip and re-flash the correct firmware in it, because he will likely continue to boot black

Feb 25, 2016 | Samsung 2232GW

2 Answers

Monitor keeps turning on and off? it wont even show the screen for more than a second or two and then switch to black again.


your LCD inverter is almost dead. the monitor itself actually remains on, but just goes to black each time the LCD inverter cuts out, since this is what supplies white light to the screen.

In case you wanted The FP5315 Users Guide, or 3 other HP documents for the HP FP5315 LCD Flat Panel Monitor:
http://h10025.www1.hp.com/ewfrf/wc/manualCategory?lc=en&dlc=en&cc=us&lang=en&product=324205&

Jan 05, 2011 | HP Compaq FP5315 15" LCD Monitor

2 Answers

Hi, when I turn my computer on the monitor shows image briefly then turns black, it stays this way until I turn the monitor off then on again, what is wrong with it?


diva_5, You will need to use warranty first. If warranty not option, You or qualified electronics technician will need to repair the "switch-mode-power-supply"/"CCFL inverter supply" so that the CCFL tubes will stay lighted for another 2000 hours. That's my best guess. Do some reading in my and other fixya lcd monitor tech's profiles for lots more info on this very common CCFL back-lit lcd monitor problem. If reading and DIY repair isn't your thing, then skip it and trade-in unit for new. DIY repair can sometimes cost less than $10 if you have tools and know how to solder. Contracting out the work will cost upwards of $40-$70. Read before you do anything about your "black" or "blank n black" screen monitor!!! Good kuck with repair. 12fixlouie

Mar 16, 2010 | Chi Mei Corporation CT522A 15" LCD Monitor

1 Answer

ViewSonic VA912 half screen dead after 30 minutes


first i confirmed that the problem was in lcd.then i predicted that some display chip on the motherboard are getting heat.due to which the display was performing irregular then i switch on A/C of my room.and the temperature was cool. and the monitor was working fine.

Apr 29, 2009 | IBM E54 (Pearl, White) 15 in.CRT...

1 Answer

Possible power supply burnt out


I've been hacking on a few of these monitors at work... we have a bunch that are dead... I have not seen this particular chip burnt (yet), but have been replacing a lot of the capacitors. To confirm the chip ID numbers you were looking at, I saw 4502C & AA5N0, and yes, they're both the same. If it comes to the caps, they should all have a flat top... if any are domed or black or sooty on the top, that is a good indication it is bad. Hope you had good luck with this. I can/t help with replacing just the chip.

Feb 02, 2009 | Samsung SyncMaster 930B 19" LCD Flat Panel...

1 Answer

The black screen monitor


Hi...there,
If you don't have one, don't needed. Just replaced the backlight inverter...

Oct 10, 2008 | Mag Innovision 19" LCD Flat-Panel Monitor...

1 Answer

Sony sdm hs73 finding the LHS73K V1.3 chip


Hi...there guys,
No, no, no.... It's not the chipset....what you guys had are a busted backlight inverter, get that replaced or repaired it. Replaced a couple of over-heated capacitors...and it will come back as good as new...

Jul 06, 2008 | Sony SDM-HS73P 17" LCD Monitor

2 Answers

AOC LM700 17" LCD Screen switches to black and then comes back to normal. Power light never goes green but monitor works. LED is orange when off and in sleep mode, wakes correctly on getting input. Just...


Hi,

According to LCDParts, an inverter for an AOC LM700 would cost $69.99. Specs (with picture) are available here.

Perhaps you can do a Google for lesser priced versions.

Good luck and kind regards.

Feb 08, 2008 | AOC LM 720 17" Flat Panel LCD Monitor

4 Answers

Monitor won't turn on, no led.


If the LCD has an internal power supply, then the inverter circuit should be on the board as the power supply. If the power supply is external, then the inverter circuit will have it own board.

What is the output of the Inverter circuit? It should have 12VDC going in, but around 50VAC going to the CCFL bulbs.

The "no led" should be a sign. Your getting voltage, but what about current? It still can be the power supply. All LCD monitors should have a "soft switch", or software driven switch to turn the CCFL lamps on and off.

It is hard to find literature on LCD repair, experience is the best teacher on this subject. This might take several emails or postings to help find the answer.

LCD monitors are a computer. You can break them into several parts, Power, I/O, and processing. Power is the easiest to trouble-shoot and repair. Processing is the hardest.

I fixed one LCD monitor by re-seating the software EEPROM. The process could not do its job if it can not read the software EEPROM.

If one of your IC's is shorted, you can always tell using a can of air. Get one of those cans of air and tip it upside down and spray the entire board until it all turns white. Now apply power to the system. If an IC is shorted, it generates more heat than anything else. It will be the first to loose the white condensation. Don't worry this is safe, done it several times.

Nov 16, 2007 | Sony SDM-HS73P 17" LCD Monitor

2 Answers

Monitor works for about 30 mins then goes blank with a messahe reading 'Not Optimum'


Hi Rick I have the same problem. Have you found a solution yet? I had the power supply tested, that is not the problem. It seems to go off when it gets hot. If I point a fan at it, it seems to last longer before blacking out. Pete

Feb 23, 2007 | Samsung SyncMaster 710N 17" LCD Monitor

Not finding what you are looking for?
Sony SDM-HS73P 17" LCD Monitor Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Computer Monitors Experts

Cindy Wells

Level 3 Expert

4757 Answers

Lala Alonsi
Lala Alonsi

Level 2 Expert

56 Answers

ray gallant

Level 3 Expert

36333 Answers

Are you a Sony Computer Monitor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...