Waher will not turn on--no lights..nothing..outlet has power and water is connected. i washed loads last night.

LG WM2277HSW XL Front Load... Repair Questions - Fixya

www.fixya.com/.../p95436-lg_wm2277hsw_xl_front_load_stackable

Recent LG WM2277HSW XL Front Load Stackable Washing Machine questions, problems & answers. ... My frontloader washmachine will not turn on · LG ...

LG WM2277HSW XL Front Load Stackable Washing ... - Fixya

www.fixya.com/search/p95436-lg_wm2277hsw_xl_front_load.../open

LG WM2277HSW XL Front Load Stackable Washing Machine, open related issues. Get free ... Wait 5 secs after turning off door release should open. If this does not ... OE error message won't open door, won't spin out water What is filters & open it are my problemsDue to that I cann't ... Where is it sticking and how do I fix it?

LG Tromm WD 12270 RD washer and dryer 'LG ...

MAY HAVE FRIED MOTOR. OR YOUR CONROLS

Possible 3 Probs 1st has the fuse blown in plug 13amp, 2 probably brushes on motor are worn down and only just making contact that why some times when u turn it its ok again,
the second is there is a unit called capistor ur machine will run erratic as this goes then stops all together the unit is silver round about 30mm X 750 long with 4-5 wires connected on 1 end hope this Alan

Have you checked the pump and filter are clear? Remove kickplate plinth panel to expose pump. Drain off excess water via small black hose. Check the hoses are clear, particularly if it is connected under the sink, via a spigot connection. If the machine has good motor action, but not spinning effectively, it will more than likely be a drainage problem.

if press button selection, make sure that no 2 buttons are pressed

Make sure your supply is open. Try rotating the timer clockwise 180 degrees and try again. It could also be a bad water valve solenoid. Make sure power supply is good.

Your drain hose is too low or there is no air gap at the drain outlet where the drain hose enters the wall.

if no lights suspect main control bd remove rear screws in top panle remove top by sliding towar back control is along rear

water level on the pressure switch is pre set make sure that nothing is in the pressure switch hose it connects from the pressure switch to the tub, if no obstruction then replace the water pressure switch

Maybe when you were behind the machine, you did not refit the outlet pipe at the correct height; this is a height approx. 3 feet from the ground or more. Your pump pumps the water OVER this height.

You said it does not spin; you shd check out your outlet filter and clean it. If this is clogged the machine will not spin. All the best!