Question about Kitchen Ranges

1 Answer

Hotpoint 6109 You suggest getting a service manual, all that I have found so far are instruction manuals that tell you how to work the oven, nothing on the wiring. Its just one big thick white wire hanging loose, that could attach at the top end to a number of places, its still attached at the bottom. Any further advice would be much appreciated

Posted by on

  • Kleanthis Mavropoulos
    Kleanthis Mavropoulos May 11, 2010

    This is referred by hotpoint help center. does it applies to your oven?

  • Kleanthis Mavropoulos
    Kleanthis Mavropoulos May 11, 2010






    My oven will not work



    Cooker timers come in various designs and configurations so always refer to your handbook for advice.

    1. Ensure the time of the day is set
    2. Ensure the manual symbol is displayed
    3. If auto is displayed, Reset the manual mode.

    PLEASE READ: In the interest of consumer safety, any adjustments, alterations or replacement parts should onlybe made or fitted by a suitably qualified and competent person with the machine disconnected from the mains supply.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,665 Answers

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

All key pad works, except to clean oven. It double beep sound and nothing happens.


Hi Carol.

First make sure that you are performing clean procedure correctly. If you press both bake and broil and then self clean, then instead of self clean the oven will go in child lock beeping twice. Two beeps may also be result of incorrect temp calibration. Perform calibration as suggested in the extract from service manual below:

10_11_2011_1_11_07_pm.gif



Before starting the self clean cycle the electronic control (ERC) performs checkout of door latch and temperature sensor, lock motor is activated and both relay for bake and broil start the cleaning cycle. If one of the conditions is not met the electronic control will beep and you may get an error code.

Make sure that both bake and broil are working. If one of the two functions is not working, then one of the relays in the power board is likely faulty: If the oven is not heating at all , then problem is usually the oven sensor.

If the rest is working the problem can be the door lock motor. The relay board and control module may also be causing the problem. The oven must be tested.

This GE range is mostly electronic. Testing is mostly done following the diagnostic procedures suggested in the technical repair manual.

The first procedure is error code reading (user level). This consists in reading the error codes stored in the oven electronic control (AKA ERC).

Here an extract from service manual showing the procedure:


10_11_2011_12_33_32_pm.gif

The procedure can be found in the Service Manual at the bottom of this document. Check page 19 of the service manual.at the bottom of this document. When performing the test look for error FF and F2, which respectively mean door latch and oven sensor problem. (codes at page 24 of service manual.

After the error code test, test individually door latch, sensor and lock motor. Perform the tests at page 22 of manual:


10_11_2011_12_48_53_pm.gif10_11_2011_12_51_11_pm.gif

10_11_2011_12_52_43_pm.gif

If the test does not return any error, then the door latch and motor must be tested manually as explained at page 21 of service manual.

HERE THE COMPLETE SERVICE MANUAL IN PDF FORMAT (click to open).

Regards.

Ginko

Oct 11, 2011 | GE Profile JGBP79 Gas Kitchen Range

2 Answers

My oven temp. varies up or down from set temp.my email adress is rmfmacre@yahoo.com


OVEN SENSOR most likely. Click on that link to view yours according to your model number.
themobilian_1152.jpg.
Yours is gas but the sensor mounts like this on most stoves:
themobilian_1153.jpg
themobilian_1154.jpg
Video: how to check oven sensor:
Basic oven fault codes and service manual are HERE

themobilian_1155.jpg

Jan 30, 2011 | Hotpoint RGB745 Gas Kitchen Range

1 Answer

Gas oven Hotpoint RGA 720 I can't light the oven pilot


There is likely some kind of gas line blockage or valve problem. This is not a do-it-yourself fix. Call a repair person.

Oct 15, 2009 | General Electric Hotpoint® RGA720PKWH Gas...

1 Answer

Need to get a manual for electrichotpoint self


There is a website i just found called managemyhome.com you type in model information they and can find manuals. i'd never heard of it before but did a search on how to order manuals for electrichotpoint selfcleaning oven. i'd think it would work for any other manuals that a person would need. worth a try.

Mar 03, 2009 | Hotpoint RB757 Electric Kitchen Range

Not finding what you are looking for?
Kitchen Ranges Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Are you a Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...