Question about Washing Machines

1 Answer

My kenmore elite with digital face wont start. just beeps when you hit the start button

Posted by on

  • riza18 May 03, 2010

    its a gas dryer, not a washer. sorry i didnt specify.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 949 Answers

Hi,

If the washer beeps when you are trying to start a cycle, the control believes the door is open.

First of all check the hinge area, the door seal and latch/catch area to make sure something is not in the way of the door being fully closed. If it is closing fine and nothing is obstructing, you will most likely need to have the door latch mechanism replaced. If you can send me the full model number from inside the door I can get you an idea of what this might cost.


Posted on May 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I turn off the sound on my new Kenmore Elite microwave?


I Believe this model has an options button with codes by numbers which are 1 thru 6 I believe. Either 1 or 2 are sound. So hit the options button and hit the number 1 it should say (sound), Then you will hit 1 again a.k.a. mute, and no more beep beep beep. If 1 is not sound then you may have accidently created a small but deadly emp, so hit stop and you must hit options and then hit 2.

Dec 11, 2014 | Kenmore EM262A5E Elite Stainless Steel...

1 Answer

Kenmore Elite quiet pak 4 will not start. Close the door and hit the power button and nothing happens. Makes the beeping sound but nothing else.



Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101
//

Jan 02, 2011 | Kenmore Elite HE4 Electric Dryer

1 Answer

My kenmore elite he4 dryer wont start


kenore elite oasis dryer won't start, when start button is held down it flashes F, book says call service center

Jun 30, 2009 | Kenmore Dryers

1 Answer

Error message


Hit cancel the amount of minutes will stay the same and then hit the start button again.

May 13, 2009 | Kenmore Elite 45986 Front Load Washer

1 Answer

Kenmore elite 45986


Make sure you have the knob on a cycle selection. Sometimes while loading, you may hit the knob and get it just in between a selection and might not start. If that isn't it, I would say you need to replace your start button. Take the control panel off and if you have a volt meter, test to see if there is a current.

Feb 23, 2009 | Kenmore Elite 45986 Front Load Washer

1 Answer

Drum light goes on and off kenmore elite oasis dryer


repl user interface ,, it has a stuck button,, order inter face

Nov 16, 2008 | Kenmore Elite HE4 Electric Dryer

1 Answer

Beeping start button


possible stuck button on inter face ,, this sounds like kenmore oasis dryer

Oct 28, 2008 | Kenmore Elite HE4 Electric Dryer

2 Answers

Kenmore Elite HE4 beeps three times when start panel is pressed and wont turn on


FWIW ... the Sears guy came by yesterday. The problem was apparently that the door latch was not operating to the extent that the sensors thought the door was open. He is replacing the latch next week. He adjusted the old one in the mean tiome and it appears to be working fine.

This kind of stunned me, since my wife reported an electric zap and the interior light burned out as the dryer went dead -- so I was sure it would be a fried circuit board -- but, no, a little jiggling of the latch seemed to clear it up....

Jun 24, 2008 | Kenmore Elite HE4 Electric Dryer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Brad Brown

Level 3 Expert

15441 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...