Question about Worx 12" 4.5 Amp 2 In 1 Grass Trimmer/In Line Edger

2 Answers

How do you repace spool

Lost the manaual , how to you replace spool

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Yes becoase it is improtante to replaceit

Posted on May 03, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 3,740 Answers

Edited from the manual:

Press and hold in the two latches Pull cap away from the spool holder. Keep the cap and spool holder clean from debris.

First take off the cap (see above) and remove the old spool.
Place new spool into cutting head. Feed one line through the eyelet, then repeat for second line. Release secured line from the cleat if needed.Reattach the cap. (see below)

To replace the cap, press it firmly towards the spool holder. Ensure that it is correctly connected by trying to remove it without
depressing the two latches.

Thanks for using FixYa


Posted on May 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

On the Featherweight, we have lost the post that holds the spool of thread. It is gone. Do you have such a replacement and if so, how much do they cost and can I install it myself?

On a featherweight the spool pin and cover are sold as one part.
I have included a link for a source on ebay, from there you will find other sources at other prices. SINGER Featherweight Spool Pin 45795 Fits 221 222 eBay
All you need is a screwdriver to change it.

Sep 18, 2017 | Sewing Machines

2 Answers

Trimmer line is spinning but slowly, like it has lost power.

Sounds like just what you said "it's lost power" Are you sure the battery is fully charged? Try another battery if you have one. There is no clutch to slip on this type trimmer. It's got to be either the battery is not putting out enough to turn the motor or the motor itself is bad.

Aug 23, 2014 | Black & Decker 18volt Cordless Trimmer 18v...

1 Answer

Lost my manaual what geat to you put it in on snow?

Hi, you run it in 4hi in the snow. 4lo is for extreme conditions, deep snow, mud etc... To engage 4lo, transmission must be in neuteral. Good luck...Coop

Dec 12, 2010 | 1999 Chevrolet Blazer

1 Answer

Replaceing string spool

if its the newer weedeater brand
All you need to do is grab the bump knob end and pull it straight off no turning
wind your line in the direction the arrows on the spool shows you
to put back insert line or lines into the holes and snap back on
be sure the spool is able to move up and down freely after install

May 26, 2009 | Garden

2 Answers

Auto feed spool doesn't work

You may need to purchase a new spool housing, which may not be too hard to do, if you have one of the name brand trimmers. This replaces the whole mechanism that holds the line, the retaining ring, etc.

Sep 21, 2008 | Black & Decker Black and Decker & Grass...

1 Answer

Have lost the back of my phone and looking for the best way to repace it. type of phone is the motorola V9 razr 2

have u lost the external covering stuff or any important element???.. if u have lost the case u can definitely replace it..u must replace the whole case... if u wish u can replace with rubber silicon case..

Apr 28, 2008 | Cell Phones

1 Answer

How can i repace the line on a black & decker strimmer gl550

Instructions can be found at:

If the line keeps getting too long, it's because swivel 14 in diagram 7 was in the wrong position when you inserted the spool - just move it to the ouside position, re-insert the spool and away you go. Frankie.

Apr 20, 2008 | Black & Decker String Trimmer Cordless 12"...

Not finding what you are looking for?
Worx 12" 4.5 Amp 2 In 1 Grass Trimmer/In Line Edger Logo

923 people viewed this question

Ask a Question

Usually answered in minutes!

Top Worx Garden Experts

Tim Whalen

Level 3 Expert

3074 Answers

ray gallant

Level 3 Expert

45324 Answers

Jay Finke
Jay Finke

Level 3 Expert

1343 Answers

Are you a Worx Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides