DC12 System Fault

Hi

You do not say which operating system you are using.

A blue screen can have many causes, so you need to undertake an elimination process to identify the cause.

Most importantly, do not repeatedly keep trying to boot if blue screen keeps appearing, as this could lead to hasrdware failure. It is important to identify and fix the fault as soon as possible.

If you read the full error message, there will usually be an indication of the likely cause of the crash as well as some suggested remedies.

Typical causes are:

Conflict with newly installed software
Driver conflict or corruption
Malware infection
Insufficient Hard Drive space
Operating system corruption
Hard Drive fault
Overheating
Memory corruption
Graphics card fault

Each of these will have a different remedy.

Start by studying the error message in more detail, try the suggested remedy options, then post again with more specific information, if necessary.

Hope this helps.

your machine IBT brush is not cleaning the stickers of the IBT clean manually

9-357 system fault

btr contact failure

change the control thermster of press roll (closer to the middle of the roll)

Whenever switchon my Dc12 The mahinc ready within 5 minutes and final stage it shows the eror like "System Fault" error code 3 -380 Switch of your printer and on. How can I solve it.

Hi ,
Sir I am have dc12 mech
its giving error code 9-354.
send me the solution as soon as posible.

what is the deal on this DC12 wich fiery and or splash are you using? Can you ping the ip address on the Fiery? Give us more info

06 codes refer to exposure lamp problems..(or scan) check lamp coming on, scan carriage position etc, don't have the code list, so carefully move the scan carriage up and down, make sure it moves OK

That is a magenta toner empty message, either the magenta is empty of there is an issue with the magenta toner dispencing.