Question about Asko W660

2 Answers

Asko washing machine won't drain. - Asko W660

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Further on to this F3 problem I had the issue on model W6461. There is a short cut to the fix, instead of taking off the grey pipe from the drain pump (the hose clips are pre crimped in the factory so as stated above are difficult to remove) try this.
Stages as follows:
1) Open drain pump door (bottom left of machine).
2) Remove black pipe and drain residual water.
3) Unscrew coin trap and remove, use a container to hold the water.
4) Leave the container underneath and make sure you have some towels ready (I didn't at the time)
5) Where the washing machine drain hose connects to the outlet or U bend connector remove this and expose the end.
6) Blow into the drain hose as hard as possible......hopefully the blockage will clear through back the coin trap.

Result:
A large lump of sludge, three of my 5 year olds small counter coins and about a litre of water.

Just ran the machine now and fault cleared.


Good luck

Jurgo

Posted on Sep 13, 2010

  • nancyk55 May 17, 2011

    The key move is the blow-back!

×

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Our Asko W660 Quattro 1600 unit would not drain. We emptied the PIN trap on our Asko unit and still it would not drain. We finally figured out that the L-Shaped grey colored that comes out of the pump (at the very bottom of the machine) was clogged with two dimes.
The annoying thing with Asko is that they use clamps that cannot be removed and put back on. They have to be removed with a combination of a flat screwdriver and a wire cutter. So you MUST have a spare clamp to secure the L-Shaped grey hose on the top of the pump after you clean it out.
Also, make sure you wear gloves when taking the top cover off the machine (you shouldn't have to, but we were trying to figure out how it all worked). The edges are razor sharp. Thanks, ASKO!!
PEM

Posted on May 14, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: My Asko 6461 washing machine - F3 code

F3 problem, I had the issue on model W6461, however, judging by the amount of F3 issues posted this could work on other ASKO models If the coin trap in the drain is clear of debris, try this. Stages as follows:
1) Open drain pump door (bottom left of machine).
2) Remove black pipe and drain residual water.
3) Unscrew coin trap and remove, use a container to hold the water.
4) Leave the container underneath and make sure you have some towels ready (I didn't at the time)
5) Where the washing machine drain hose connects to the outlet in the wall or U bend connector remove this and expose the end.
6) Blow into the drain hose as hard as possible......hopefully the blockage will clear back through the coin trap.
7) Pour some water into the open end and blow this back through the drain as well.

Result:
A large lump of sludge, three of my 5 year olds small counter coins and about a litre of water (all over the floor, don't forget the towels!)

Just ran the machine now and fault cleared.


Good luck

Jurgo

Posted on Sep 13, 2010

  • 133 Answers

SOURCE: water draining makes loud noises

if water isn't draining properly the cycle will stop thereon check the drain pipe

Posted on Oct 12, 2009

  • 351 Answers

SOURCE: Asko W6461 - will not drain

is the pump comming on look inside the pump with a tourch there may be somthing stuck behind the impeller

Posted on Apr 09, 2008

  • 351 Answers

SOURCE: I have an Asko 10505

front right corner the pin trap turns to the left and pulls out it may be stuck pull hard.also check the yellow impellor to see if it is loose

Posted on Aug 27, 2008

  • 1 Answer

SOURCE: asko 10625 will not spin

it is probably the belt, take off the back of the machine and look at the black rubber belt that spins the cleaning drum. The belts break after about 5 years, you can get a replacement belt at you local Asko dealer, I recall that is was pretty easy to change, like doing a bike chain, Talk to you Asko dealer about how to change it.

Posted on Jul 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Asko 10625 washing machine wont drain or open


Take the bottom panel off and there is a large drain under the drum. There will be a lot of water that comes out, so be prepared. When you take the drain off, there should be a debis trap in there. Clean this out look to make sure there are no socks or anything in there.

Nov 27, 2013 | Asko Washing Machines

1 Answer

Asko 620 washer won't drain well with heavy load


Washing machine won't drain

When your washing machine won't drain, it could be as simple as a kinked hose or as complicated as a faulty impeller on the pump. Overloading your washing machine can cause items to be swept into the space between the inner and outer tub, leading to clogs in the drain hose or pump. These clogs may be the reason for why your washing machine won't drain. Here are some steps to help you determine the problem and solution:

1. Pinched hose: Is the drain hose at the back of the washer been flattened or twisted in any area? A pinched hose could prevent the water from draining thoroughly. Gently straighten the hose, and make sure there is sufficient room between the back of the washing machine and the wall to prevent a repeat of the problem.

2. Clogged drain hose or pump:
Does the drum spin normally, but the washing machine won't drain the water? Sometimes a piece of clothing, money, fabric or other debris gets into the water between the inner and outer tub. It may then make its way into a drain hose or even into the pump itself. The farther into the machinery a clog goes, the trickier it can be to remove. Call a repair professional for help.

3. Faulty timer: Does your machine fill with water and begin agitating, but the cycle never advances far enough to allow the water to drain? The timer that controls the cycles may be broken. Arrange for washing machine repair service.

4. Worn or loose belts: Are clothes still soaked at the end of a wash, even though the washing machine appears to go through the spin and drain cycles? The timer that controls the cycles may be broken. This is a job for the pros.

5. Faulty or jammed internal impeller on pump: When the spin cycle starts, do you hear a humming noise? The internal impeller that moves the water through the drain pump may be faulty or jammed. A grinding or grating sound is almost always an indication of a coin, button or other object colliding with the impeller. Have a washing machine repair expert determine if the impeller is jammed and can be cleared, or if the pump needs to be replaced.

6. Pump failure: Is your washing machine more than 7 years old? Your pump may simply have worn out. Even if it sounds as though it is running, the pump may not be working well enough to draw the water out of the machine. Replacement parts for pumps are generally unavailable. A new pump may be necessary.

For more troubleshooting steps, see Washing machine won't drain. I hope this helps!

Oct 08, 2012 | Asko W6021 Front Load Washer

1 Answer

My ASKO W6222 won't drain


Sounds like the inlet water valve is not seated properly and is letting water in when it shouldn't .

Jun 20, 2012 | Asko W6222 Top Load Washer

1 Answer

My washer w6221 won't drain


Check this following things then your washer will be fine.
* Has the drain hose been put flat on the floor?
* Is the drain hose clogged with lint?
* Is the drain hose kinked?
* Is any part of the drain hose higher than 20 cms from the floor level?
* Is the extension drain hose longer than 3 m?
* Is a narrow drain hose being used?

Thanks for your question.

Jun 26, 2011 | Asko W6221 Front Load Washer

1 Answer

Asko 1475 dishwasher - won't wash. Circulation pump?


Check your drain. It is dual purpose. It not only drains but, it also recirculates the water doring the cycles.

Aug 10, 2009 | Asko Dishwashers

1 Answer

Asko 10625 will not spin


it is probably the belt, take off the back of the machine and look at the black rubber belt that spins the cleaning drum. The belts break after about 5 years, you can get a replacement belt at you local Asko dealer, I recall that is was pretty easy to change, like doing a bike chain, Talk to you Asko dealer about how to change it.

Mar 29, 2009 | Asko Washing Machines

1 Answer

Asko w640 has a water inlet fault


Check the drain line to make sure the water does not siphon out as it enters the machine.

Mar 10, 2009 | Asko W640

1 Answer

Washing machine fills with water when not in use.


Either your pressure in the main line bringing water to your machine is insufficient; or your intake water valve is defective; which you can replace easily.

Feb 22, 2009 | Asko Washing Machines

1 Answer

I have an Asko 10505 Front Loading washing machine. It will spin but ill not drain.Where do I look on the Machine to see if there is a problem with the drain pump. I am in Australia


front right corner the pin trap turns to the left and pulls out it may be stuck pull hard.also check the yellow impellor to see if it is loose

Aug 25, 2008 | Asko Washing Machines

1 Answer

We have a code F3 on our asko washing machine


Most likely a drain pump problem. Make sure there is nothing in the drain hose. Then it would be a bad drain pump

Jun 09, 2008 | Asko Washing Machines

Not finding what you are looking for?
Washing Machines Logo

1,317 people viewed this question

Ask a Question

Usually answered in minutes!

Top Asko Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Chris Hall
Chris Hall

Level 3 Expert

842 Answers

shaun taylor

Level 3 Expert

1525 Answers

Are you an Asko Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...