Will not turn on

Did you replace all the wires on the positive side? Also the negative cable bolts to where on the frame? Check those

• Mate have you checked the battery and cleaned all lead ends. Even a new battery is sometimes be defective, have you got a mate with another battery to install to test to see if it is battery!
• I would try that first if bike runs with another battery then you will know. Cheers

Test the battery

soo Have the provider install new batteries. No telling how long the "new" batteries sat on a shelf and in the showroom without being charged. The batteries are warrantied and should be replaced. While you're at have them check out the scooter after the new batteries are installed and remember to charge before use. Hope this helps

Was the camera dropped??

If it wasnt dropped try changing the batteries.

install a new or fully charged battery/batteries into the camera.



1. If the camera is on, turn it off.
2. If any accessories (memory card, lens, USB cable, camera or printer dock, etc.) are connected to the camera, remove/disconnect them.
3. Remove the battery/batteries from the camera.
4. Verify:
That you are using the correct battery/batteries for the camera
That the battery/batteries are correctly installed
That the battery/batteries are fresh or fully charged
Follow the battery installation and charging instructions in the camera User Guide
5. Turn on the camera.

Check for:
1. if plugs spark, could be a dead puter. 2. if electric gas pump is working 3. If central alarm wont let car start

turn on your headlights ,then turn key like your going to try and start the engine and see if the headlights dim dramatically, then you'll know if you have a good connection to starter from battery, then check chg on new battery

Take the batteries out. Install the batteries making sure they are inserted according to the camera diagram on the inside cover. Once the batteries have been installed correctly turn the camera on. If it does not turn on, check the ON/OFF Switch.

Make sure that you have them installed the correct way +/- and also check that the old batteries didn't leak and cause corrosion on the battery connection tabs.

Are they of the correct type according to the manual If they are then contact Olympus Technical support.