Question about Minn Kota Edge 40 Freshwater Bow Mount Trolling Motor

Open Question

Minn kota trolling motor all terrain 40. motor has quit working on all speeds. seems to be in 4th speed and will speed up a little when move to 5 speed. no other speeds. have been informed it was the speed coil, whatever that is, as no one can tell me. can any year motor be used to replace present one? Have new 1996 AT55/H but dont think wiring is the same coming out of the motor. Don't know if the at55/hand will work in place of the present at40?. Has anyone else had this problem with minn kota all terrain 40 as I have two of them doing the same thing.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 8 Answers

SOURCE: Need wiring diagram

Call Minn kota, the number should be on the bottom of the head. They will e-mail it to you.

Posted on Nov 28, 2008

  • 8 Answers

SOURCE: how does the minn kota 65 all terrain run on 24

You should only run the motor with a 24v battery or two 12v batters 'jumped' out. To jump the two batteries, connect the positive on one batter to the negative on the other battery and hook the trolling motor battery cables up to positive and negative terminals that are NOT jumped out as you would normally. Don't run this with 12v as you will have serious problems if you do. They do not make a 65lb thrust in 12v - too much pound thrust to run off of 12v.

Posted on Sep 07, 2009

  • 8 Answers

SOURCE: On a Minn Kota All Terrain trolling motor, what

You should only use the MOM (or momentary) setting when using the push button the foot pedal. Con will just keep the motor running and your foot control will only allow for direction and speed!

Posted on Sep 07, 2009

bigcass
  • 35 Answers

SOURCE: is a minn kota mag 36 just 12V or 12V -24V run

I believe the Mag 36 is a 12v and the Mag 40 is a 24v......Ive been doin a little research and cant find anything that points to a 12 and 24v system.....

Posted on Jan 19, 2010

  • 122 Answers

SOURCE: How many amps does a minn kota 80lb thrust motor draw ?

max is 56amps on 24v system

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

RT 40 speed setting problems


bad mother board theres 2 in it one in head one in motor

Mar 27, 2013 | Minn Kota Riptide 40 Transom Mount...

1 Answer

What sizebattery is recommended for a Minn Kota RT40/s riptide motor


Hi, you can get away with a 70 amp hour deep cycle battery but I generally fit a 100 amp hour deep cycle battery. Hope this helps, regards Phil.

Jun 29, 2011 | Minn Kota Riptide 40 Transom Mount...

1 Answer

I have a 5 speed forward minn kota only 3 speeds work ,I replaced the speed control box but have the same problem


Check the Relay's these will be found in the control module, Most likely totaly sealed, test or replacement may be required

Aug 26, 2010 | Minn Kota Maxxum 55 Freshwater Bow Mount...

2 Answers

Trolling motor stays on same speed no matter where I set the speed 10 -100. It is at a mid range speed.


I just recently had a simialr problem. No speed control and motor only ran at 100. I talked to the minn kota tech rep and sent him my control board and he said it had a bad potentiometer...however, I had to buy a control board to fix the problem ($215). Hate to say it but sounds like you may need a new control board.

Jun 24, 2010 | Minn Kota Maxxum 70 Freshwater Bow Mount...

1 Answer

Is a minn kota mag 36 just 12V or 12V -24V run


I believe the Mag 36 is a 12v and the Mag 40 is a 24v......Ive been doin a little research and cant find anything that points to a 12 and 24v system.....

Jan 19, 2010 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

On a Minn Kota All Terrain trolling motor, what should the MOM/OFF/CON switch be set to when using the foot pedal manually?


You should only use the MOM (or momentary) setting when using the push button the foot pedal. Con will just keep the motor running and your foot control will only allow for direction and speed!

Jul 06, 2009 | Minn Kota Maxxum 70 Freshwater Bow Mount...

1 Answer

I need a truster speed for a Minn Kota Endura 46


Hi!
Here is a scchematic with part numbers and service center listing as well:
Endura 46
Best of luck!
Mike

Jun 21, 2009 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

My brother inlaw got a minkota 40ta all terraine trolling motor that is supposed to produce 40 pounds of thrust. it does not seem to produce even close to that. is it possible that the motor is turning the...


I would check the battery. If you're using an old or under charged battery you will loose power for sure. Make sure you're also using a 12v deep cycle marine battery as this will ensure proper operation and a longer battery life.

Apr 18, 2009 | Minn Kota Edge 40 Freshwater Bow Mount...

Not finding what you are looking for?
Minn Kota Edge 40 Freshwater Bow Mount Trolling Motor Logo

Related Topics:

438 people viewed this question

Ask a Question

Usually answered in minutes!

Top Minn Kota Boating Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

14534 Answers

Phil Walker
Phil Walker

Level 3 Expert

605 Answers

Are you a Minn Kota Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...