Can i use my W1926 in New Zealand where they have

Check the screen filter where the cold water line attaches to the machine. Clean both hot and cold.

Is this it ?http://www.mieleusa.com/manuals_pdf/Residential/Washers/W1926_us.pdf

1 Remove stacking kit from top of unit.
2 Reatach the two plastic clips to the back of washer.
3 engage the two slots on the washer top into the clips , pull forward drop lid down on top of washer then secure with two screws on either side of lid.

all you need to do is to purchase a power converter also known as transformer that converts the European 220v to110 v, so that American appliances will operate on European current.

The power may not be compatible from USA to New Zealand, look for a traveler power converter. Hope this helps

Hi Yugin.That indicates your machines water inlet valve is faulty.(Means it's taking less water then normal)Please check this steps & do it fast before water inlet is finishes:1-Turn your machine on & run empty with pre-wash cycle first.2-Please ajar the detergent drawer & check runing water on compartment one 3-Please press pre-wash button & compare the running water volume on compartment two.If the running water volume 1 is less then 2 or vs.water valve needs to be replace.That's causing problem.I hope that helps.Thanks.

I'd start simply.

They do move over time and if the floor is not even the machine will be out of balance.

If you have not done so check the machine is still level and all feet are solidly on ground.

Try to shake the machine by hand and see if is solid on the ground. There are leveling legs under the unit you can adjust.

Hope this helped. Please rate answer if it does.

if i were you fist of all open door then you will see the silver drum on the inside lift the silver drum upwards from the top of it and if you feel a knocking sound then the bearings have worn out expencive to replace them,as sometimes you have to have a complete new drum.rgrds,paul

That happened to me too. If the machine is a few years old and the hoses are not kinked it's possible the water inlet valve needs to be replaced. On this machine there is a triple cold water valve and a single hot water valve. Mine needed the triple valve and it is about $300 if I remember. Check to see if it's the cold or hot water valve by looking at the water filling through the soap drawer for cold or hot water cycles. When the valves go bad they run but the output is very low which causes the light to flash because it can't fill to the correct level.

You can get to the valves by taking off the top. If you don't feel comfortable working on your own machine have a professional do it.

You could have a bad mixing valve. I would suggest replacement.