Question about Sony VPL CS1 Multimedia Projector

1 Answer

Sony svga vpl cs1 projector horizontal roll

I have a sony svga vpl cs1 projector and the picture starts rolling horizontally. I tried it on different DVD players so it is the unit that is doing it. Any suggestion

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 75 Answers

First of all open the projector and clean it form a bursh then cheack a losing if stips and jumpers thats it

Posted on Apr 24, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The horizontal hold


If model number correct (the one posted here) set does not have a horizontal (rolls left to right) or a vertical (rolls top to bottom) control.

Verify model and brand so I may offer some suggestions

Mar 22, 2012 | Mitsubishi VS-5075 50" Rear Projection...

1 Answer

When the projector warms up the picture starts to roll intermitently.


It is possible that your projector has the syncronisation fault in the video processor section. There is a possiblity that the chip is faulty or the corresponding allied cirrcuits have sprung up with some passive component weakness. What you can do is to open the set and warm up the areas near the main chip . Switch on the projector and if you notice the roll had stopped try do it to specific components and finally to the main IC .Replace when you are confirmed but attempt only if you are experienced or seek help to replace. Hope this helps. Good day

Aug 10, 2010 | Sony VPL CS1 Multimedia Projector

2 Answers

Sony svga vpl-es2 won't work


Its because for the foot there is switch who give signal to micro processor or system control.Fix it that.Your problem will solve.

Jun 23, 2010 | Sony VPL-ES2 Multimedia Projector

1 Answer

Hello with Sony VPL-CS1 projector in standby mode


overheated or lamp is past it's time. you may need to change the lamp, replace the lamp timer. while you're in there, clean it out.

Apr 18, 2009 | Office Equipment & Supplies

2 Answers

Projector SONY VPLCS!


I had the same problem with a Sony VPL CS1. It's not the mainboard, but the blue filter - cost to repair runs around $500 US.
Hope that helps.

Mar 21, 2008 | Sony VPL CS1 Multimedia Projector

1 Answer

Sony VPL-CS1 projector


Hi there

You should first check if there is any visible damage on your lamp. If not then it could be a faulty Ballast ( lamp powersupply )

Mar 14, 2008 | Sony VPL CS1 Multimedia Projector

1 Answer

VW10HT screen filled with horizontal lines until unit warms up (5-10 minutes!)


I have a similar problem with our projector. It help to reverse the output for some reason. When reversed, all horizontal banding disappears.

Jan 22, 2008 | Sony VPL VW10HT Multimedia Projector

1 Answer

PROBLEMS WITH VERTICAL ROLL


That is not a vertical roll from side to side, this is a horizontal rolling. if the vertical had a roll it would be going from top to bottom. This is most likely a coupling between the horizontal sync circuit and the sync separator circuit. Good Luck

Jun 28, 2007 | Sony KP-53S65 53" Rear Projection...

1 Answer

Horizontal Green Lines!


Hi Tim

I've seen this many times. Only way to get rid of it is to replace the Mainboard.

This will get worse as time goes by.

Jan 17, 2007 | Sony VPL CS1 Multimedia Projector

Not finding what you are looking for?
Sony VPL CS1 Multimedia Projector Logo

Related Topics:

507 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Office Equipment & Supplies Experts

shaun taylor

Level 3 Expert

1525 Answers

Jaime Hernandez

Level 3 Expert

2315 Answers

The Knight
The Knight

Level 3 Expert

73698 Answers

Are you a Sony Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...