The ice dispenser only give crushed ice. It will not do the cubes anymore.

Refrigerator - Crushed Ice Only, No Cubes. If it appears you are getting only crushed ice from the dispenser, check the following: It is normal to get a slight amount of crushed or broken ice cubes before or while dispensing cubed ice. ... If no ice cubes are behind the bucket, try to dispense ice with the bucket removed.

You might need a new Control panel for your Ice dispenser.

Your selector solenoid is bad. It is usually located behind the ice bin in a white box with the auger motor. Most of the time they are good still, but they get frozen. Try to defrost it.

Your selector solenoid is not working. Next to the auger motor there is a selector. You will see a plastic peice in a hole to the left of the auger.....Try to move it up and down. If it won't move it is more than likely frozen in one spot. Try to defrost it. If that does not work then replace the solenoid.

You have a solenoid switch which switches the dispenser back and forth from crushed to cube. It could be stuck or not working or the parts connecting it could be disconnected or broken. You will have to observe to see if any parts are moving and if any noise is coming from the solenoid

You have a solenoid switch which switches the dispenser back and forth from crushed to cube. It could be stuck or not working or the parts connecting it could be disconnected or broken. You will have to observe to see if any parts are moving and if any noise is coming from the solenoid

I have a GE TFX25ppbaaa refrigerator. The ice maker corkscrew motor would run and provide crushed ice only. The corkscrew motor would not run when the switch was moved to the cubed ice ( half moon) setting.

I replaced the large Light/ water/ crushed ice/cubed ice switch , ( product service number GEH WR55X129 ) ( part number GE 162D6372 PO17 )and it fixed the problem. Cost was about $43.00.

hi there,

could be that the ice maker arm is getting stuck or may have some frost on it. can you supply the complete model # please?

Pull out your ice bin. In the back of the bin you will see a rod protruding from one side. That rod goes into an opening in the rear of the freezer. There is a solenoid behind that opening that raises and lowers the arm on the ice bin giving you crushed or cubed ice. Check to see if that solenoid is froze up or if your rod got stuck under it. If all check ok then replace that solenoid.

Check and make sure your switch is okay. Some have a switch that controls whether you want crushed or cubes. If it is defective replace it.