Error msg on turn on - Epson Stylus CX6600 All-In-One InkJet Printer

Hello Pls replace the fuser with new one your problem will be resolved if problem persists then replace the dc controller bord.

Sounds like the System Bios Settings changed from SATA to ATA. Change to SATA.
Good Luck

You press # * at the same time...... with the navegation arrows you go up to system configuration, with the arrown you navegate until you see error report...then you clear the error report.....then you turn off the printer...unplug everything from it.. unplug ac adapter from the wall wait 1 minute... then plug power back....turn on printer an Voila...is working

flatbed scanner needs replacing.

Lens error is usually caused by mechanical faults concerning lens assembly. The lens cannot extend or retract fully, the error is detected and lens error is returned.
Sometimes this can be fixed playing with the lens during extraction or retraction to help the lens asset getting back to normal.
More often the camera lens must be disassembled and re-assembled by a technician to fix the problem.

give the lens a turn

unplug printer
remove network card and cable
plug printer in & turn on.
wait for boot sequence
unplug printer
reinstall network card and cable
plug in / turn on.

If it wont calibrate, you have a bad toner cartridge.

use only GENUINE HP

Just fixed mine. :-) I highlighted in yellow a small absorbtion pad that sits under the "home" position for the ink heads. This pad was tilted on its side and prevented mechanisms from moving. Once I put it back in its place, everything appears to be working. You might be able to reach this without taking the cover off, but it is tricky. See http://www.fixyourownprinter.com/forums/inkjet/37440 for some info on care with cover removal.

in my network i have hp M1005 printer always i'm getting this msg "scanner error 6 turn off
then turn on"
when i make turn off and turn on again same msg comming

how can i solve this problem...