Question about Sony KV-T29CF1 TV

2 Answers

Dead Sony KV t29

Sony KV t29. worked well for years and suddenly stopped working....dead. When you switch on all you hear is a "bshh" sound then a ticking/pulse (about 2 per second) around the psu and eht side. Can't see any dry joints nor sign of overheating parts (by touch). I'm hoping someone has had a similar experience and can help. I have no diagrams . Plse help. much appreciated...Kind regards Marcie57

Posted by on

  • Marcie57 Mar 29, 2008

    Thanks Mr Niceguy

    50% success so far. Found cracked joint and shorted 2SC4927. Where would I find the main regulator ICs and the white .1ohm resistor? Would apperciate you feedback

    Bst Rgds

    Marcie57

  • Marcie57 Apr 02, 2008

    HI MrNice guy. Repaced the transistor and checked all components as described. No other problems. TV works wonderful now. Thank you for your help. Much appreciated. Have a good day. Marcie57

×

2 Answers

Excellent job

Posted on Apr 04, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 301 Answers

Check the horizontal output transistor for short. if so then check main regulator ICs for short and white .1ohm resistor for open. also check horizontal transformer for cracked solder as this is the cause for failure

Posted on Mar 29, 2008

  • MATT BECKER Mar 31, 2008

    if you look at the deflection board from the bottom side. the regs and resistor are on the left side of board on other side a large transformer. they ar e3 legged devices. the resistor is acting like a fuse and can be easily seen from the top side. check all components and see where you get. remember to check the horizontal transformer for cracks, should be near C4927 i think that it is a 6 pin trans that is where the fail started.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony kv36hs500 tv, suddenly no power, no standby lights, no sound


U check the power source?Take the tv aparts,check or replaced the power fuse,might get lucky.Not,than sorry,this tv can't be repair,without replacing electronic's componnents parts.Hire the same shop to do the repair.Ur tv power ICS inverter are dead.

Jun 15, 2010 | Sony FD Trinitron WEGA KV-36HS500 36" TV

1 Answer

Sudden death


Take out ur antena,cable ect.. input have any noise.Or tv could have dead video.

Aug 16, 2009 | Sony FD Trinitron WEGA KV-24FS120 24" TV

1 Answer

Sony trinitron kv-36fv26 (2000) tv wont show picture


Trires unplug,replug about an hour later see if it reset it self.Not take to the shop the two power ICs help the power it dead.Need it replaced.

Jan 27, 2009 | Sony FD Trinitron WEGA KV-36FV27 36" TV

1 Answer

Sony KV-T29


You may still need to check more components

Since your wake up LEDs are Active ( working ) this means your stand by 5 voltage is working.

Since your Standby 5 Voltage appears to be working but you still do not have a fully working set
you may need to check your High Voltage Components.


Thank you for electing FixYa!

azkeyz@fixya.com
IEEE Certified Electronics Engineer.
Wizard Division

Sep 23, 2008 | Sony KV-T29CF1 TV

1 Answer

KV27FV300 PIP


I think that is dried solder try to re solder the video chroma ic or change the capacitor 250v/10uf near the FBT (flyback)section

Apr 27, 2008 | Sony FD Trinitron WEGA KV-27FV300 27" TV

3 Answers

This TV worked very will until the past two weeks when it refused to start up


Any sound? If so, it could be a bad display or high-voltage or associated problem.

No sound and no picture could be a bad line cord, power switch, blown fuse or AC problem.

In this case, make sure it is plugged into the ac outlet and the ac outlet is getting power by plugging in a lamp that is known to work into the outlet. If it does not light, then ther is no ac power at the outlet and you have a bad fuse or tripped circuit breaker (most likely) or (less likely) a faulty outlet or break in the house wiring.

Good luck! :)

Mar 08, 2008 | Sony KV-36XBR400 36" TV

2 Answers

Sony KV32s45 sudden failure


heard a pop sound -- then the set went dead -- no lights, no nothing, and then there was a slight electrical burn smell coming from the back of the set :(

It's an old 32" set

Nov 19, 2007 | Sony KV-32S45 32" TV

1 Answer

Sony KV-32S36 32" suddenly stopped working, no picture or sound


Check soldered in fuse R607 in power supply circuit =
If open, replace it and bad converter xistors ( 2SC4834)
Next, replace shorted horizontal output transistor w/ first Quality.
Solder any / all bad connects,esp.horiz drive to base of horiz.
o / p xistor. Soldering is critical or it will blow up again......

Oct 27, 2007 | Sony KV-32S36 32" TV

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

kakima

Level 3 Expert

102366 Answers

The Knight
The Knight

Level 3 Expert

72670 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1667 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...