Sound My E-string ( 4 string bass Line 6 Vari ax) sounds much louder than the rest - mvh Gunnar Kungur Sweden

There are two sites I go to for most of my guitar/amp needs. Youtube and the second is StewMac.com and look in the Trade Secrets and How to section. It may not be the exact guitar/bass but it's a real good jumping off point.
I just opened a youtube site and searched "how to rewire a bass guitar" and received 8690 how-to videos.
Good luck on this project.

This is a list of All the parts you need, I don't know about a schematic?

1 Maple Neck ? 1 11" wood rim ? 1 11" notched tension hoop ? 1 Flat head alloy tone ring (Optional bell brass available) ? 1 Resonator (not included in the open back kit) ? 1 11" Remo frosted banjo head ? 1 Arm Rest ? 2 Coordinator rods with hanger bolts (one longer than the other) ? 1 "L" shaped tailpiece bracket (may be attached to coordinator rods) ? 1 5th string nut ? 4 Guitar style tuners (planetary tuners optional) ? 1 Geared 5th string tuning machines ? 24 Shoe style lugs with bolts and washers ? 24 Hooks and nuts ? 1 Nut, pre notched ? 4 Resonator plates ? 4 Brass inserts (brass anchors that are threaded on the inside) ? 4 Resonator bolts (knurled on the outside with a Phillips screwdriver receiver on top) ? 1 5 string bridge ? 1 Gary Price style Tailpiece ? 1 Set of strings ? 22 Pre-cut (ready to install) frets ? 1 Truss rod cover (including three screws)

I would need the complete serial #s, this serial # would be a 1968. Fender did not manufacture a Deluxe (or active) Bass guitar line at that time.

This sounds like a worn nut groove. The string is sitting too low. Does the buzz happen all the way up the neck or just on open string?

You friends bass has a burr on the saddle. take a small fine file and go along the pacth of the string...Go over the saddle and slowly file lightly..This should get rid of your problem...take it to a service center if you arent comfortable doing this

The internal workings of the guitar - pickups, potentiometers, switches are not grounded.
Very common.

Protective circuits kicking in. You may be overdriving the preamp to a clipping condition the amp sees as a problem. If it is under warranty, contact Line 6 and see if this is normal for this amp. It should not be, but you never can be sure.

Try adjusting with the EQ settings on the amp... boost the bass and trim the highs.

This is likely a problem with the amp you are using. Turn the treble up higher. If the amp is intended for a bass guitar, it probably can;t handle the highs of the E string. In that case get an amp that has a smaller speaker or one that is intended for Keyboards that has the capability.

I hope you dident screw it up, a person can realy mess up the platability in a hurry if you dont know what your doing. Lets see if we can get you on a good track .What your looking at is your tali pice. that whitch holds 6 saddels the saddels have horizontal screws. Hex you need a very little alan wrench. they normaly come with a new Ax.string heights are 2.00 at the 5.th and 1.5 on the 1first. use a line of sight to see that strings are in a good line. Never Never screw the vertacal screws with springs. Thisis your intonation. if you mess this up you lose the playabilithy of you gtr. ps Guitars dont come with manuals. check with your local music stoer. find a musician thats will ing to give some hands on tips.