Question about Refrigerators

1 Answer

Fridge problem my ice/water dispenser quit working last night. It has been sporadically "thumping". The trap that closes the ice dispenser (in the door) keeps opening and closing for some reason. It is a Maytag MFI2568AEW. If you have any suggestions I would appreciate it. Jason

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Refrigerators Master
  • 2,651 Answers

Yea you have a bad high voltage board, part located on back wall of rear of the unit. easy part to replace yourself, unit will come with directions to program the refig after your done installing it.

Posted on Mar 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The ice dispenser and water dispenser on the door will not work


"Prepare for the worst" This is a problem i'm currently dealing with at the moment, ice maker thaw'd and refroze the ice as a block, binding the crusher turbine till it quit working. then water dispenser started spitting till it quit working, but anyway i disconnected the ice maker and water dispenser power hookup, because when i tried to use it it was drawing off the power of the fridge. now i'm to the point where fridge clicks like the relay is going out. in the back of the freezer below the ice maker tray i removed the clip or screw to where when it clicks i can hand spin the cooling fan on the click, and fridge starts up and runs, but don't remove this panel because having it on helps the air push into fridge compartment and keeps cooling elements from turning to a block of ice, " so long story short " its either your cooling fan or relay on chip board that starts cooling fan, i'm no expert but this is where i'm at hope it helps.

Jan 02, 2011 | Whirlpool 25.6 cu. ft. Side-by-Side...

1 Answer

No wate coming out the dispeser


The plastic water resivoir in the fridge compartment is frozen. Need to locate the resivoir which is at the bottom of the fridge and by using a hairdrier, warm the plastic resivoir for about 6 minuites. Suggest you turn the fridge off while doing this. retry and dispence water.

Jun 06, 2010 | Samsung 26.1 Cu. Ft. Side-by-Side...

1 Answer

Whirlpool Door Ice Dispenser Not Working


mine froze up in the shute, had to put water down iti

Aug 26, 2009 | Whirlpool GS6SHAXLS Side by Side...

1 Answer

MAKING ICE BUT ICE AND WATER DISPENSER QUIT WORKING.


Sounds like a plugged water filter, assuming the water is turned on to the fridge. If you have a manual, refer to the section about water filters. The filter is usually accessible from the front of the fridge at the bottom....requires about a 1/2 turn counter-clockwise. Some units require that the water be turned off first but not all.

If you do not hear a click when activating the dispenser, there could be an issue with the water solenoid (water valve) that opens and closes when you use the water dispenser....agai...check the manual if at all possible.

Apr 17, 2009 | Frigidaire Refrigerators

1 Answer

ICE MAKER QUIT MAKING ICE ON MY WHIRLPOOL FRIDGE


I had a Whirlpool Model GD5SHAXNS in which the icemaker quit working about the same time (3 years old). I had water out the dispenser, I found that it was the icemaker itself failed not calling for water to fill it. I replaced it with a icemaker on-line for about $100 and problem fixed. I have been told his is a common problem with the icemaker in this model ref.

Mar 26, 2009 | Whirlpool 25.6 cu. ft. Side-by-Side...

2 Answers

Ice maker not working


what filter? drying filter? Water filter? Dust Filter?

Jun 24, 2008 | Frigidaire FRS26R4A Side by Side...

2 Answers

No water or ice through door


sounds like the dispenser assembly is not sensing that the trap door is opening fully, so it wont send power to the auger motor or fill valve. If you are pretty handy, you can disassemble the door and take out the dispenser assembly and try to take the assembly apart and correct the throw on the trap door. Otherwise, I'm afraid you need a new dispenser to the tune of about $250 parts and $225 trip and labor. Good luck!

Nov 07, 2006 | Sub-Zero 690 Side by Side Refrigerator

Not finding what you are looking for?
Refrigerators Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4636 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...