Question about Cell Phones

1 Answer

Lg 8700 cellular phone lcd replacement

The lcd on a lg8700 cell is cracked I've removed the small rubber covers and the two phillips screws, how do I remove the plastic bezel without breaking it?

Posted by on

1 Answer

Removice a plast

Posted on Oct 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am set up on my laptop put can not take pictures off of my lg8700 cell to my laptop


transfer ur photos from phone memory to memory card memory..now remove the memory card and read it in your laptop with memory card reader!!! thanks for using fixya!!!

Nov 18, 2009 | LG VX-8700 Cellular Phone

2 Answers

LCD screen broken, have parts, want to know how to change them


THIS is what everybody else leaves out!!! first open ur phone and there are four sticker pads in the corner, use something with a sharp point to remove. Then use a phillips screw driver to remove the screws. the top with now come off, next there is a ribbon cable from the touch screen to the screen itself, On the connector there is a small plastic lever u will need to flip up in order to release the cable. Use a solder iron to remove the wires and it helps to write down on a paper where they go! do NOT LEAVE THE IRON ON THE WIRES TOO LONG!!!!! just enough to melt the solder and remove the wire, same for putting the new ones on! Next carefully remove the screen, it is held in place by sticky tape, be careful not to crack the cover, just be patience and do it slow! and put the new screen in in reverse order!!!! hope this helps!

Tallcool1

May 04, 2009 | LG VOYAGER VX10000 Cellular Phone

1 Answer

LG Shine 8700 user manual


Click the link below to download the manual in English:

lg_shine.pdf

If the download does not open, then install again acrobat reader.

Apr 13, 2009 | Cell Phones

1 Answer

Am looking for tear down instructions for lg scoop


a #00 phillips screwdriver
a prybar (plactic manacure looking stick)

-there are 6 screws on the back housing,
-then 2 screws on the motherboard
-then 3 silver screws on the slide
-then another 6 screws on the back of the front housing
-gently slide small tabs on lcd out of front keypad, when reinserting new lcd, insert ribbons to white line
-reassemble

you can dig into the two pieces of housing with the pry bar, it will not damage the phone

Mar 23, 2009 | LG RUMOR Cellular Phone

2 Answers

How do you replace the lcd screen on A LG shine KE970


Take off the back plate that houses the battery, undo the four screws, then look where the bottom of the battery is just below are two cover caps remove and undo the two screws below now separate the cover. There is a circuit board under neath the panel unplug may seem tight but go careful, underneath this there are a futher six screws undo these and the two halves of the phone will separate. Now undo all the screws you can see here including the two that are under the two covers at the top they look like moulding marks separate the halves, undo the screws on the roller switch,lift this and you will find a ribbon connector that appears to be glued it's not, go careful and separate. Congratulations you have now removed the LCD. All you have to do now is remember which screw goes where and reverse the whole process. Good luck.

Feb 08, 2009 | Cell Phones

1 Answer

LG Shine 8700 user manual


Try these
http://cache.vzw.com/multimedia/mim/lg_vx8700/

http://www.telusmobility.com/content/clientcare/pcs_east/guides/lg_8700/LG_8700_Eng_UG.pdf

Oct 22, 2008 | LG VX-8700 Cellular Phone

4 Answers

Lg 8700


After a while, the battery becomes slightly loose, so battery connection is intermittent. Simply put a small wedge (small piece of cardboard) at the top of the battery compartment, so that when you renisert the battery, it forces a tight connection on the bottom connector. I have fixed 5 phones this way. Intermittent connection causes the blutooth to drop, and battery to appear to not hold a charge well. THIS IS SO SIMPLE, yet nobody knows about this! It's worked on EVERY VX-8700 I've tried it on.

Feb 14, 2008 | LG VX-8700 Cellular Phone

1 Answer

HELP!!!!


I found one on ebay for $25, it's really not that bad to replace, just take your time, and take out the phillips head screws, take the battery out first and then remove the 4 screws, then take out the 3 screws securing the pc board, then remove the 4 lower screws, and then the 2 on top near the camera, under the rubber covers

Feb 05, 2008 | LG CHOCOLATE VX8500 Cellular Phone

2 Answers

How to change my faceplate


The face plate snaps on, unless your talking about changing the front LCD cover. Then I would take it to my local service provider store and let them do it. It's there job.

Jul 02, 2007 | LG C1500 Cellular Phone

Not finding what you are looking for?
Cell Phones Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cell Phones Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18299 Answers

IT Solution
IT Solution

Level 3 Expert

805 Answers

Are you a Cell Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...