IM250 not firing.

most probably a faulty firing pin, but I recommend you visit the attached link, it worked for me with my sporadic firing Im 250. Fixing Paslode gas framing gun that wont fire or fires intermittently

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

-]0]0-

Make sure the battery is charged - it will not provide good combustion.

Next - make sure the plunger is fully depressed - there is an adjustment on the side.

Finally - check for proper operation of the trigger.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

0-0-

1.If fan is work check gas cell(use only paslode gas) and best before date(expired date)
2.If fan isn't working check that the battery is fully charged.
3.Make sure filter is clean and you can see through it.(no dirt or grit)
4. If after that it still isn't working you will have to take to your nearest paslode repair agent.(check on there web site for your local repairer)

good luck.!

sounds like its losing presure when fireing it could be the next oring if its the rubber one replace if its the metal one take them out and clean the grove they sit in and make sure u space them, meaning the gap in the rings should be set 180 deg apart. this should work if u r getting a spark when the gun is apart. the cable could be making a bad contact at the spark unit and when u r checking this make sure its getting a good contact at the spark plug as well hope this helps u.

Yes,this is a common "mis fire" by Pasilode. I own the 16p Framer and the Angle nailer and I never get it from the Framer but I do get it seldom from Trim Gun,nothing you can do ,its just a misfire.

Please rate jj505

Please make sure use by date is current on bottom of fuel cell. If no date buy new fuel cells with useby date. Fuel has lost its ignition flash point. please reply.

Bad Fuel cell!!! New cyliders now have expire date on bottom of cannister. If old will not fire properly. Put new fuel cell in should be fine.