Trying to send a fax and get the TX #0259 what does it mean and what do i do to be able to send the fax

Hey!

A rx error is a error in reception on the fax!!Tx is a sending error!!It can be on the side that sends you the fax and not on your side!!

Hope it helps!

If the "Mode" was "Tx" or "Snd", you tried to send a fax, and the other fax machine did not answer, then it was either turned off, or out of paper or ink. If the mode was "Rx" or "Rcv", it means your fax machine tried to receive a fax, but none was sent. If your machine was in TEL/FAX or FAX mode and it received a regular call, the caller heard the fax tone and hung up. If your machine was in ANS/FAX or EXT.TAM mode, it most likely means a regular voice caller heard the answering machine and hung up without leaving a message.

your fax RX memory is full and needs to be cleared however this should not stop you from sending transmission TX immediately however if you are going to send a memory fax you will have to clear the memory for machine to be able to store the TX you are trying to send

I have a Minolta Fax 3900 and it at times while trying to send a fax will say *tx cancel* and only send 2 pages of a fax. It appears like it does send the fax but it might not be the complete fax. I can't cancel the fax or stop it either. Does anyone know how to fix this problem.

No, it did not go through, it keeps trying to send it until you press STOP while it is redialing.

Press funcktion ,dataregistration,scroll down until you get report settings,press ok and scroll down to tx report,press ok and change to output yes.
Then you will receive a report for every fax you send.

i believe it means rx receive and tx transmitt


in rs 232 communication (serial communication modem fax etc) line 2 is tx (transmitt and 3 is receive rx hope that helps

It means you have a fax in memory that cannot be sent.

Do you have DSL or any kind of digital phone line? Do you have a dial-tone?

Unplug the power cord and re-plug.

Hey renzo737 - Follow these steps to have your machine print a report after you send each fax:

1)Hit the Fax button, then the Menu button.
2)Press the < and > buttons to scroll until you reach
TX Settings. Hit OK.
3)Use the < and > buttons to scroll until you reach TX REPORT.
Then hit ok.
4)First you want ATTACH TX IMAGE and then you want
PRNT FOR EACH TX.(it may also say as TX REPORT)

On your machine under TX report it may just say PRINT ERROR ONLY, which means only print if there's an error, or the PRNT FOR EACH TX. You'll find it easily. You want the print for each tx option. This will print a report and give confirmation that your fax went through after each fax. If you have any problems understandind this or need more help just give a shout.
If this solves your problem PLEASE rate this as fixed. Like I said if you need more help just add a comment and I'll be happy to assist you further. Thanks and have a good one.

Jeff

:

of course..is that phone line, by chance a high speed internet connection?