Minolta Copier - 1031F - How do you clean the drum and the brushes

Pull out the image unit. have the drum removed check the cleaning blade is it yellow replace it. IF you can fine run ! Clean the drum off be careful no liquids USE a clean brush. NO vacuum cleaner the static electricity from the vacuum cleaner can destroy the Developer sensor (Unless you know how to do it). Remove the Transfer assy. located below the drum (Push down and out From the rear also) clean also

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Odds are you need a new drum cleaning blade. The only problem is trying to find parts for the copier. Good Luck

It is not hard to do... The question is are you a service tech or just want to do it your self. If you are not a tech, it is best to leave it to someone who knows how to do it. It can & will get ugly fast if your not sure on how to do it......

the issue you have is that the cleaning blade is worn and you will need to replace the cleaning blade This will fix your issue also make sure the fuser rollers are clean

Minolta ep3000 Cspro error code c0000 is plz sloved it

cleaning blade out of order can caused black line.

Clean the OPC drum unit and the charge corona

Drum cleaning blade has gone bad. Especially true if the streaks seem to get progressively worse as you run multiple copies. In other words run 10 copies. If the last one out is worse than the first one out it is the drum cleaning blade. Cheap part...around $25

Clean the mirrors in optical section

probably your drum is dirty and machine needs cleaning.