Question about Kenmore 24032\24036 Top Load Washer

1 Answer

Dosen't spin all the water out of clothes. - Kenmore 24032\24036 Top Load Washer

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 185 Answers

Make sure your not overloading your washer

Posted on Mar 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ge toploadwasher that does not get water out of clothes after final spin


Could be that the spin cycle is not rotating at the required speed to wring out your clothes. Check that the cycle completes at a significant speed to generate centripetal acceleration forcing out the water. Perhaps the load is unbalanced which can trigger the spinning cycle to repeatedly stop during the spin cycle.

Jan 31, 2015 | GE Washing Machines

1 Answer

My mastermind 708 dosen't spin after wash cycle.It spins fine in the wash cycle but dosen't drain water or spin in the spin cycle.Pease help


Your empty pump filter is blocked with debris. If it can't evacuate all the water then it wont allow the spin cycle to start. Locate the filter (probably behind a little door at the botton of the front of the machine). Remove, clean and remove the debris, re-fit and all will be well

Jul 01, 2011 | Westinghouse Washing Machines

1 Answer

Hi can you tell me which programme is the short wash and spin please


I think I have the same type of washing machine as you do. Wash is when all the clothes get agitated or mixed with soap and water (ever look in there when its washing? the water can get pretty gross looking!) So in my washer, the rinse cycle is when all that gross water is drained, and the washer spins while spraying clean water over the clothes to get rid of the dirty water and soap. I think mine does this 5 or 6 times in the cycle. Next is the spin cycle, which is when the washer spins REALLY fast to **** as much water out of the clothes as possible, so that the clothes aren't sopping wet when you put them in the dryer.

It sounds like your mom has a newer washing machine, probably a front load one, and they do seem to keep using clean water, instead of just agitating the clothes in dirty water.

May 17, 2011 | Electrolux EW1000i Front Load Washer

1 Answer

Fisher and paykel ecs washing machine.The agitator dosen`t turn any more so the clothes aren`t getting clean.The spin is working ok.What could the problem be??


This can a problem with the program controller unit as during the cycle there is no power to the motor so as to agitate.
You will need to check the controller , try with another program if not check the output when the wash cycle is on.

Feb 19, 2011 | Fisher and Paykel GWL11 Top Load Washer

1 Answer

The water runs during the spin cycle. The clothes


Does the water run through the ENTIRE spin cycle? There is a period where the water will run during the spin; This is called, the "Final Rinse". But it usually only runs for about 10 seconds then stops.

Dec 22, 2009 | Washing Machines

1 Answer

Water left in clothes


The shaft was designed to rotate into 2 directions: one for agitation, one for spinning. The spinning direction is controlled by a mechanism from the clutch engagement. When your plastic pulley wears out, it effects the mechanism to spin. The driving force for spinning is slipped, therefore the spin is weak As a matter of fact, the water remaining in clothes n in turn discharges to the bottom tube

Jul 02, 2009 | Maytag Washing Machines

1 Answer

Washing not spinning water out of clothes


Must be something in the pump obstructing the water flow.

Jun 14, 2009 | Washing Machines

1 Answer

MY WASHER DOSEN,T SPIN CAN HERE THE MOWER


Well if it will pump water out then that old drive coupling is probably broke. This happens when somone puts a rug or comforter in this washer or leaves too many clothes in there with too little water. It is easy to fix. Read these pictures and directions: kenmore/whirlpool washer no spin

Award winning eye openers:
http://repair2000.com/coupling.html
http://appliancejunk.com/motorcoupler.pdf

Mar 30, 2009 | Whirlpool Duet GHW9150P Front Load Washer

2 Answers

Spins fine, but clothes still soaking wet


Clogged water pump. Not draing fast enough. If this is helpful, please post as such.

Feb 21, 2009 | Maytag Performa PAV2200

1 Answer

Washer spins but not enough to extract water from clothes or tub.


could be a loss belt or a kinked hose, since you say it feels weak i would think it is not getting up to speed which would be a loss belt or drive train issue, of course it could just be to big a load or on slow spin speed setting

May 22, 2008 | Washing Machines

Not finding what you are looking for?
Kenmore 24032\24036 Top Load Washer Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Jesus  Colon
Jesus Colon

Level 1 Expert

12 Answers

Fred Sops

Level 2 Expert

271 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...