Question about Bosch Axxis+ WFR 2460 Front Load Washer

2 Answers

Bosch WFR 2460 washing machine

My Front Loader Bosch Axxis+ says pump is blocked. I take off the cap in the front and lots of water comes out, but there is no blockage in the pump. When the next load is started, sometimes the pump works, but more often it doesn't and so the cycle stops. I have removed all pipework from drum to pump and found no evidence of blockage, i have also removed all pipework from pump to drain, this also shows no signs of a blockage. When i spin the pump impellor by hand it give a magnet type resistance every 180 deg turn, is this correct or does the pump need replacing? (should the pump impellor spin free and smooth?)

Posted by on

  • kokohi May 10, 2008

    The machine message is pump blocked but I am unable to take off the pump cap! Is there a secret to removing it?

  • Anonymous May 28, 2008

    I have the same problem. Moving the impeller helps but only for a while. Then it gets jammed again. Maybe it is time to change. Plan to dismantle it later, will share my findings.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I have the same problem, I even replaced the pump and still getting the same message, so it is not a problem with pump, it is may be the control pannel, a sensor is not sending the message to the pump.

Posted on Aug 21, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 236 Answers

The pum should do that but the magnet side may have saturated with water beyond the seal. i recommend replacing the pump.

Posted on Mar 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bosh wasmachine doesn't was clothes


Remove hose at washer connection and check screen filter not blocked with grit from pipes. Check screen at tap end also. If both clear, machine may need water valve replaced.

Mar 23, 2010 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

Hello, I just placed a load of laundry in my Bosch Axxis washer and set the dial to the cycle I always use. However, the water will not come into the washer, and now all of my clothes are stuck inside from...


Try selecting the spin prog, if there is any water in the washer, this will drain it, and you should be able to open the door.
Please leave comment as to whether this solved your prob or not.
Thankyou.

Nov 25, 2009 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

I have a bosch WFR 2460 washer. Er:15 error code.


You need to check and clean pump filter, normally located behind a removeable plastic cover at bottom front of washer right hand side.
If no filter found there remove rear panel of washer, and clean pump from rear of washer.
Please rate my solution.
Thanks.

Nov 11, 2009 | Bosch Logixx WFT 2806 Front Load...

2 Answers

Not spinning


Axxis+ WFR 2460 Front Load Washer This washing machine tutorial will show you what to do if the washing machine does not drain or empty the water out this repair was done on a Bosch, Neff and Siemens type appliance.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Dec 28, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

No draining indicator says pump blocked


could be impeller broke off or loose on motor shaft also may be blockage in lines to or from pump and not in pump it's self

Oct 25, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

Display field


Not sure if the 2450 is compatible with the 2460, but here is a parts diagram that shows the display module, part #AP3854652, for $97.69 from AppliancePartsPros.com. I ordered replacement carbon brushes and a drain pump from them and have been happy with their service.

Mar 12, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

My Axxis wfr 2460 is not releasing the fabric softner from the drawer


You could try a tooth-brush. And after you fill your quantity of softener, top it with water till the exit level of the compartment. You could also check whether water actually pours into the compartment during the final rinsing of the clothes; in this case you should check the inlet pipe screens of your inlet pipe into the machine; which can be done without opening up the machine.

Nov 30, 2007 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

Pump blocked message


next time u clean the filter when it is empty of water. put your finger in the whole and u will find somthing wound round the impeler of the pump remove what ever is obstructing and u will have no more problems make sure u unplug the machine b4 you start doing this good luck

Sep 03, 2007 | Bosch Axxis+ WFR 2460 Front Load Washer

Not finding what you are looking for?
Bosch Axxis+ WFR 2460 Front Load Washer Logo

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Tim Whalen

Level 3 Expert

3056 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

yadayada
yadayada

Level 3 Expert

61292 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...