Question about ICOM Informatique BP-85S, ICOM,IC-W2A,IC-2SRA,IC-4SRA,IC-2SAT,IC-3SAT,IC-4SAT,IC-24AT,IC-RI,IC-X2A, 12v 1100mAh NiCd ... 2-Way Radio

1 Answer

IC-2SAT Can the internal battery be replaced? If so, where would one find a replacement?

Posted by on

  • Gymd Mar 18, 2008

    TY jmerrix. Battery ordered

  • mosico Jun 07, 2013




1 Answer


1 Suggested Answer

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

IC-736 total failure whilst on air, fuse OK, nothing smelt burning etc, not over heated, no voltage surge, SWR was moderate but protected by APC circuit. Totally dead now.

Hi Jack, (No Pun Intended)

As this is such a fine radio, I would take it to the radio doctor for a once over check-up, The technician will find the problem and give you an estimate of cost to repair the fault, Take care of you radio, it's a great unit that should give you many more years of service.

I hope this advice is of help to you.


Dec 02, 2012 | ICOM Informatique BP-84SM,...

1 Answer

No video output on my supra lcd 42, audio is ok

Its input-output selector switching IC is faulty. this IC, an electronic switching device, that switches the internal and external audio vidw in-out and is controlled be main system control IC. When we select the function to internal or external, the signals goes through this IC according to the control pulsed generated by the main system control IC, with our command. In your set, the video section of this switching IC is OK, but audio switching section has damaged. It wont switches the video to out, but alright in case of internal video switching. So you can see picture either with AV of by air transmissions, but there will be no audio with AV.
Replace the IC is the only remedy to rectify this problem. It is really a skilled work, and you must have through knoledge in digital electroncis to do this work. It is besf for you to get it repaired by any experienced service technician. The IC won't cost more; and can be bought from most of the electonic sparepart shops at your town. OK.

Jul 15, 2011 | Televison & Video

3 Answers

Nokia 6300 Cellular Phone

try to replace a new and tested one..if still fast drain your nokia 6300 is shorted and need to remove the shorted parts..thanks

Jun 10, 2010 | Nokia 6300 Cellular Phone

1 Answer

Problem with SmartUPS SU5000I

Before trying to replace an IC, make sure that the battery is capable of holding a charge. If there is more than 1 battery, check all. If it (they) are bad, it will probably be less expensive to replace the unit.

Jul 24, 2009 | APC (SUA3000I) UPS System

1 Answer


You have an IC (Integrated Circuit) that has shut off internally. Try complete power down (remove any electrical power - includes any internal batteries) overnight. Then try again. If this doesn't work, it's an IC malfunction.

Jun 20, 2009 | Electronics - Others

1 Answer

The phone won't switch on. I put it on charge, then when I disconnected the charger I found that the phone was dead and won't switch on. I've tried removing and replacing the battery and SIM but it's


There might be 2 reasons for the same.

1. An internal Ic might have been blown. In this case, you need to open the cell. Remove the battery. with the help of a Voltmeter, check the voltage across all IC's. The blown IC would be a bulged or seemd to be swelled.Replace that and the problem would be fixed.

Even if you repair it from outside, it would not hurt your pocket.

2. Motherboard - If this is at fault, you might need to pay around half the amount that you spent on cellphone.It's really hard to fix and more likely demands a replacement. The main disadvantage, you cannot use motherboard of some other cell. It has to be a unique one i.e same model.

Note - I am considering that the battery is fine and fully charged. If not sure, swap the battery.

Thanks for using Fixya.

Do rate the solution as "Fixya" if 100% satisfied.

May 25, 2009 | Nokia 6600 fold Cellular Phone

2 Answers

Getting sound from center channel only on my JVC-TH-M505

check the jack female and male jacks r allright
the connection is correct u need to check these first
then u if nothing works use the fuse replacement

Mar 07, 2009 | JVC TH-M505 System

1 Answer

ICOM W2a Won't power up, after full charge with two different batteries

There's a comment on about charging the internal battery first.

Maybe this will help you.

Jan 10, 2008 | ICOM Informatique BP-85S,...

Not finding what you are looking for?
Radio Communications Logo

Related Topics:

1,083 people viewed this question

Ask a Question

Usually answered in minutes!

Top ICOM Informatique Radio Communications Experts


Level 3 Expert

1655 Answers


Level 3 Expert

4062 Answers

Robert L Kershaw

Level 2 Expert

72 Answers

Are you an ICOM Informatique Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides