I have a kenmore dishwasher model 665, an the quick wash light keeps blinking. and the appliance will not work. i have tried pushing the cancel botton , the start botton. all it does is the quck botton stills blink, and no responces. can you tell me what is wrong. thank you E. P.

Try this, unplug it from wall outlet for one minuet to reset its processor. Then plug it back in to see if that worked.

Check the control panel ribbon cable that plugs into the control board behind it. If everything works well, you will need to replace the control panel. You provide me with the colour or your appliance, I will supply you with a part #.

Sound like you have a bad control console, which will need to be replaced.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

lock light is locking the panel push this child lock button for 3 sec and see if it un locks . then try it again .. may have a pannel out. mm

Sounds like a defective control board.

Sound like door/latch is not providing a secure door close anymore. Push on the door when the lights flash and see if this stops the blinking and continues with wash cycle. If it does, there is either somehing interfering withe the door closing fully, or the door latch on the door or dishwasher side is worn/defective.

kenmore lite blinks on quick rinse, seems to be stuck on that.

key pad need to be change

The blinking button lights indicate the buttons are bad. The console will have to be replaced.

you'll need to enter a diagnostic mode, press in this order, hi-temp(sani-rinse)----heated dry--hitemp---heated dry... all lights should light, close door and let cycle for about a min, after press the cancelbutton, you should be good to go, the buttons on your model may read slighty different names, if this "toggle of buttons" does not work, you can remove thelower access panel and htere willl be a tech sheet/trouble shoooter behind the panel, in there it will explain how to enter diag/test mode