Wont spray the cleaner n water out - Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Try cleaning the Flow Indicator Filter. Turn the Flow Indicator Cap counter-clockwise to remove, lift rotor and filter. Clean filter and replace in reverse order. Bissell's Consumer Care # 1-800-237-7691

Well what I had to do was replace the pump motor you will have to take it apart and look to see if it has ant rust then look at the pump witch it is a white canister looking thing see if it ceased up and then use 3n1 oil or wd40 on it and work with it tell it is free spinning! Then it will work

Hey Patti, spray is important when you want to clean. Here's a link to toroubleshooting steps to assist you.

http://www.bissell.com/FAQDetail.aspx?id=1122

Can you help me need new rubber for the brush as I have broken it can I have a replacement please

Take the water tank off, you should see 2 spraying nozzles. You need to get to these and clear them out with a needle or something. Did the trick for me.

Or could be the pump itself. Confirm this using the hand tool - if it sprays water then the pump is fine.

it wont spray water but it willpick the water up

First try putting in a little hot water in the water resevoir , let sit for about about 5 mins. then try it. if this doesn't work, flip the machine over and locate the spray jets on the bottom. You'll need a pin or something small enough to clean out the jets bye sticking pin or paperclip in it . Detegent left in the machine sometimes cloggs the jets.Empty water before you flip the machine over.

I have the same problem, can someone help.

Thanks

Go to bissell.com go unger frq.asked questions. Also check your belt