Question about Superstar SS-148DX 40-Channels Base CB Radio

2 Answers

How do you turn OFF Roger Beep? I don't have the manual, Thank You.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

THE ROGERBEEP IS BUILT IN ON THESE RADIOS AND YOU CAN TURN IT OFF. YOU NEED TO HAVE IT MODIFED WITH A SWITCH SOMEWHERE ON THE RADIO. I CAN DO THAT FOR YOU. SEE MY WEBSITE A WWW.COBRAMAN148.COM.

Posted on Feb 28, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 46 Answers

Hello..i don't have a direct solution but i have an adress for you that i think can help you...even if all you need is the manual...here it is httpp://www.radiomods.co.nz.......this is a very good site!....good luck ...Ron

Posted on Mar 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My roger beep will not work


Can you specify what model/make transceiver you have. Most exports transceivers have the roger beep function next to the TX/RX switch near the mic connections and microphone audio amp.

Sep 27, 2014 | CB Radios

1 Answer

Galaxy saturn ...roger beep just chirps no beep


either a capacitor has changed value or someone changed it. with the board facing you --front right where the mic connector would be on a mobile unit is were the roger beep components are. make sure none are blown or no resistors are burnt. We can restore it back to a factory beep if you would like.

Dec 17, 2010 | CB Radios

1 Answer

HOW DO I INSTALL ROGER BEEP ON A GALAXY 33 CB RADIO


Does the roger beep come with instructions? It can vary between beep boards.

Typically it gets installed inline with the mic jack.

There is a wire or pin on the board where the tx wire, and the rx wires go.These wires get disconnected from the mic jack, then a wire goes to the tx pin. Then there is an audio wire that gets connected to the audio wire of the mic jack. Then the black wire to ground, and the red wire to switched 12v right off the power switch.

Here is a schematic of the board connected to the mic jack so you know what pin is what.

Again, I would need to know what roger beep board you would like to install.


Feb 22, 2010 | Galaxy Radios DX-33HML 40-Channels Base CB...

1 Answer

Roger beep will not turn off.galaxy saturn turbo.


It should have a switch to flip to turn it off,check to see, experiment with it......dont know how someone wired it, then i could tell you .hope this helps.

Feb 18, 2010 | CB Radios

1 Answer

Saturn turbo roger beep don't turn off.says it's off but it's not off.


Take the cover off, could be a faulty switch,undo the wireing to it and tie them together,...hope this helps...

Feb 05, 2010 | CB Radios

1 Answer

I would like to turn off the roger beep on my BellSouth model 229


You need to open the radio and look for the roger beep board. It should be a white wire going to one of the pins on the mic jack. If you interupt that wire the tone will not play. You can either disconnect it, or put a switch on it so you can turn it on and off.

Oct 04, 2009 | Superstar SS-148DX 40-Channels Base CB...

1 Answer

No roger beep does the freq counter have anything to do with it?


the roger beep circuit is next to mic connector and tx/rx cirucuit. the freq counterDISPLAY is on seperate circuit.

Sep 29, 2009 | Galaxy Radios DX- 88HL Base CB Radio

1 Answer

Fitting a roger bleep


you should be able too. A single tone beep is usually small. About 2 x 1 inch or less. A 5 tone is a little longer, but they usually fit right by the speaker no problem.

May 01, 2009 | CB Radios

2 Answers

Want to disconnect the bleep altogether on my cobra 148 gtldx


If this is a stock cobra 148 gtl 40 channel am plus side band, they don't to my knowledge come with a built in r beep. Some roger beeps are instaleed through the transmit circuit on the mic, so if not in the know Don't try to fix it.Some microphones have a beep built in. I used to install beeps on these radios using the pa/cb switch to turn them on. also try the nb switch or the swr/rf switch.

Feb 04, 2009 | Cobra 148 GTL 120-Channels Base CB Radio

Not finding what you are looking for?
Superstar SS-148DX 40-Channels Base CB Radio Logo

Related Topics:

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Superstar CB Radios Experts

AnyMHz.com
AnyMHz.com

Level 2 Expert

489 Answers

Iron
Iron

Level 3 Expert

3018 Answers

tjanzer

Level 2 Expert

59 Answers

Are you a Superstar CB Radio Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...